Find trusted local electricians near you

Was advise something has been chewing on wires need electrician to look at truck

Achoo thousand rex Hall Airbus RV generator will not stay running longer than five minutes then my lights flash on and off and then I have zero power

Need help pulling permit for an Level 2 charger, electrical loan calculation and single line diagram for the 240V circuit, manufacturer specs for EV charger and specify any panel upgrades or wiring plans.

Hookup new on demand water heater to existing NG service (old NG heater will be removed prior to your work) and install new flue (unit is in garage next to outside wall). Reconnect to existing water inlets/outlets.

I was delivered a new wire part for an E Bike and installed the wire bike runs but the part they sent me is 2ft long and I can’t fit it all back into the bike without impeding the battering , the bike does run and turn on tires spin and monitor shows everything just can’t use the bike with wires sticking out

Install outlet for microwave and dishwasher. Install water heater in a existing closet. Fix a leak under the sink (bathroom). Dishwasher needs pigtail. Price is labor only by the hour

When I turned my key on my starter was automatically turning over I replaced the starter and haven’t been able to get it started since

Home Wiring & Rewiring Hello , My property is a duplex(2 Apartment Units) with only 1 Meter at present. We'd like each unit to have it's own meter and another meter for common area (panels upgrade) totaling 3 meters How much will you charge to do it? Rough estimate, it might be more or less! Thanks, Lateef Sodunola

I need the water heater shed done and water heater. Install 1x on face if house—paint and stain concrete driveway.

I have a new ceiling fan but most homes that are old like mines may need more than just install may need to put a box in probably extra support for the weight of the fan and the light.

My inground pool light recently stopped working. I replaced the light bulb but it still won’t turn on. I suspect that either the GFCI outlets next to the pool are broken or maybe the circuit breaker needs to be replaced. I‘ll have replacement outlets and breakers ready, just in case.

Install generac 6853 switch (already purchased) and outlet in garage, right next to existing circuit box for home and connect critical circuits

The recliner is two years old. It will not recline. The power cord works but when plugged in to recliner the green light turns on and off.

Electrical problems with bike, Starts only with jump but has a -10 draw while power is off. Checked fuses, replaced stator and regulator, and starter relay. No diagnosis available with the tools at hand.

I would like to install a chandelier in my bedroom on a vaulted/slanted ceiling. There is no electrical box or wiring. The chandelier weighs about 13lbs so I need a professional to help me securely install the chandelier.

2006 Yamaha r1 battery constantly draining due to I assume is the wiring. Once I hook up the bike to a tender and let it charge it starts right up with no problem and it stays on so I don’t think it’s the stator. I’m pretty sure it has something to do with the wiring itself since the dash light does not come up nor do the high beams work. There’s a lot of wiring that’s connected to nothing underneath the front fairing.

I need a light installed in my ceiling. Will require electrical wires to be connected etc

Seems the battery is charged with Ignition and nothing comes on.

I have a pergola in my front yard that has a power strip. Need electrician to run wire through the yard from the house line to the pergola. Approximately around 10 to 50 foot depending where it’s run from, so the source will need to be identified from two possible places.

So I will say I did it myself which I guess it wasn’t the right way to do it but I cut and extended 4 wires to install my relocation kit for the ECU. It was good for a few months but now I’m having an issue with a connector and well it’s a short in a wire when I moved it while the car was on. So imma get new wires and well just needed it soldered this time. All I did was twist the wire which I think isn’t cutting it anymore. The car runs but just having a short in the wire. I will get fresh new wires and shrink wrap and I will also point out the 4 wires