Hire a professional washing machine services in London

The upper hinge on my integrated Hoover washing machine door has pulled out, and the MDF/particle board around the hinge cup is damaged/stripped (see attached photos). Because this is an integrated appliance, the door undergoes a lot of vibration. I am looking for a handyman who can provide a permanent fix. Requirements: - Repair the "blown" wood hole so the hinge sits securely. - Ideally, use a metal hinge repair plate to reinforce the area (preferred method). - Ensure the door is properly aligned and level so it closes flush with the cabinets. - Please bring your own tools and necessary hardware (plates/filler/screws). Note: Needs to be done ASAP.

Need old washer taken out and new one installed

Washing Machine Removal & Installation + Water Valve Hi, I’m looking for someone to: • Disconnect and remove my old washing machine • Install and connect a new washing machine (same location) • Connect water supply and waste pipe • Install a shut-off / anti-leak valve for the water supply Everything is in the same place and easily accessible. No major plumbing changes required. Please bring any basic tools needed. I can provide the valve if required, or you can include it in your quote.

Washing machine needs installation

Washing machine has gotten really noisy, online suggests could be either the drum belt has snapped, the bearings are worn out, the motor and/or motor capacitor is faulty and will need replacement. Not sure what it is, it’s not wobbling or uneven it’s inside that’s noisy. Need it to be repaired pls

Replace the seal on Siemans washing machine

Washing machine issue e20. I’ve had to replace the drain pump previously l. Please first check if any issues

Hello, I need a washing machine connected, it's in a new building. The wash pipe and waste pipe. I have a few pictures to give you an idea. Please I need this task completed.

Washing machine leaking, unsure why

Washing machine SMEG WDI14 C7

washing machine door sealant replacement PROFESSIONALS ONLY I already have the part Only labour needed to fit part

Disconnect old washing machine then connect new machine

Hi, I need someone to help with a drainage problem. My washing machine isn’t draining properly and when it does drain, the dirty water backs up into the kitchen sink. There’s also stagnant water left sitting in the washing machine drum and it smells bad. I think the shared waste pipe between the sink and washing machine is blocked or draining very slowly. I need someone to inspect it, clear the blockage, and make sure the washing machine drains properly again. Ideally looking for someone affordable as it should be a quick job.

Current connector to washing machine has a slow leak (as evidenced by the limescale on pipe on the picture). The valve needs replacement, the pipe needs clearing of limescale, and the dishwasher needs reconnecting.

Experienced Plumber Needed My washing machine currently pumps water into my kitchen sink drain, causing water to back up into the sink when running a wash cycle. Both appliances share the same waste pipe and this issue persists even after basic cleaning and checking for blockages. I am looking for an experienced plumber who can: -Diagnose the plumbing configuration under the sink and washing machine.Identify and fix any underlying blockages, incorrect connections, or pipe sizing problems. -Reconfigure connections and pipework if needed, so that water from the washing machine never backs up into the sink. -Advise on and implement any long-term solutions to prevent this issue from recurring. Please respond with: -Your plumbing experience with similar drain/waste pipe problems. -An estimate for inspection, diagnosis, and full repair.Approximate timeline for completion. -Task must include all parts, labour, and a warranty for the fix. Job Location: London, SW129AZ

Washing machine needs to be connected to water supply under kitchen sink.. May need to add a new valve to pipework to allow connection. Plus a minor leak under sink, may need resealing or quick fix with plumbers mait.

I need my washing machine removed, and the new one installed

E10 error code. I’ve got this working again so many times checking for kinks, water pressure and the inlet but eventually the same code appears each time we try to dry the clothes and also when washing. Machine is a Zanussi Lindo 1000

Remove washing machine that no longer works for scrap.