Hire a professional washing machine services in London

Move washing machine to New place and set it up. And get rid of the old washing machine

Install washing machine inlet valve (capped pipe) I need a washing machine water inlet valve installed under my kitchen sink. There is already a capped pipe in place, but no threaded connection for the washing machine hose.

I need a section of the skirting board in the kitchen cut out to be able to remove the washing machine which is currently integrated so we can install a freestanding one. need the sides where it has been cut left neatly and not rough.

Install new washing machine and remove dispose old

Bad drain smell when we run a wash and sometimes an error code (OE) which is linked to blockage.

Pick up washing machine and deliver to SE185QF - make sure it’s installed

Fitting of new Beko washing machine - old hose appears to be leaking so new hose (which was included with new washing machine) would need to be connected to the isolation valve (see photo of old hose attached to isolation valve). Waste pipe is currently routed behind kitchen units so new one would need to be connected to the old waste pipe which connects with sink waste.

Our dishwasher is leaking slightly - only a small amount each wash so may just be a simple fix

Hello, I need a washing machine connected, it's in a new building. The wash pipe and waste pipe. I have a few pictures to give you an idea. Please I need this task completed.

Washing machine leaking, unsure why

Washing machine SMEG WDI14 C7

washing machine door sealant replacement PROFESSIONALS ONLY I already have the part Only labour needed to fit part

Disconnect old washing machine then connect new machine

Hi, I need someone to help with a drainage problem. My washing machine isn’t draining properly and when it does drain, the dirty water backs up into the kitchen sink. There’s also stagnant water left sitting in the washing machine drum and it smells bad. I think the shared waste pipe between the sink and washing machine is blocked or draining very slowly. I need someone to inspect it, clear the blockage, and make sure the washing machine drains properly again. Ideally looking for someone affordable as it should be a quick job.

Current connector to washing machine has a slow leak (as evidenced by the limescale on pipe on the picture). The valve needs replacement, the pipe needs clearing of limescale, and the dishwasher needs reconnecting.

Experienced Plumber Needed My washing machine currently pumps water into my kitchen sink drain, causing water to back up into the sink when running a wash cycle. Both appliances share the same waste pipe and this issue persists even after basic cleaning and checking for blockages. I am looking for an experienced plumber who can: -Diagnose the plumbing configuration under the sink and washing machine.Identify and fix any underlying blockages, incorrect connections, or pipe sizing problems. -Reconfigure connections and pipework if needed, so that water from the washing machine never backs up into the sink. -Advise on and implement any long-term solutions to prevent this issue from recurring. Please respond with: -Your plumbing experience with similar drain/waste pipe problems. -An estimate for inspection, diagnosis, and full repair.Approximate timeline for completion. -Task must include all parts, labour, and a warranty for the fix. Job Location: London, SW129AZ

Washing machine needs to be connected to water supply under kitchen sink.. May need to add a new valve to pipework to allow connection. Plus a minor leak under sink, may need resealing or quick fix with plumbers mait.

I need my washing machine removed, and the new one installed

E10 error code. I’ve got this working again so many times checking for kinks, water pressure and the inlet but eventually the same code appears each time we try to dry the clothes and also when washing. Machine is a Zanussi Lindo 1000

Remove washing machine that no longer works for scrap.