Find an experienced local venetian blind repair expert in East London

E11 - Leytonstone close to Leyton Tube I have a Venetian blind above my staircase that needs hanging. I have a stepladder available and the kit I bought from Amazon comes with screws / parts.

The cord has broken and now the blinds can't be raised or lowered.

Hi! I need help repairing a faux-wood Venetian blind. The cord used to raise and lower it seems to have come loose or stretched from its attachment point, which itself seems to have become a little loose. I think it should be a fairly simple repair — it happened while I was just trying to raise the blind normally, without pulling hard or forcing anything. I’d need someone to check the mechanism and reattach or tighten the cord/fixing point. Thank you!

I have an internal Venetian blind with a cord and rod control. While I was raising it, it tilted: one side remained higher than the other, and the slats bent. The control cord is still resisting, so the brake seems to be working, but the internal ladders/cords have loosened and come loose. I opened the casing and don't see any broken gears, but the lifting system appears to have disengaged or a cord has come loose or broken. I'd like to know if it can be repaired or if the lifting mechanism needs to be replaced. I've already disassembled the Venetian blind and have photos of the inside of the casing that show the problem.

Replace one broken top bracket on a Venetian blind. The blind itself is not new but in good condition, Would prefer to keep it if possible . (We added a cord to keep it working)

1 Venetian blind from argos, to put up on a single window. Requires drill work but straight forward.

Venetian blind cord needs replacing and rethreading

I need old blinds taken down and new wooden Venetian ones hung up. There are two sets that measure 120x160 and a smaller one that is 60x160.

One of the cords is fraying and close to breaking

Need 2 Venetian blinds fixed, one is the bedroom upstairs, I couldn’t drill the hole deep enough to fix the mounts, and I have an other one to do in the kitchen window (drill on tiles)

Need new Venetian blinds installed (will require drill as don’t have one), otherwise believe everything comes in the blind kit. Please only experienced people. Into brick / masonry so will require brick anchors for the screws

The Venetian blinds have been made to measure and measured by the company that supplied them. The window is to 135° angle with a small blind for each window.

Z Venetian blinds 2 pull-down blinds

Removal of a large set of Venetian blinds. The blinds are high up (4-5 metres high) so you will need to bring a ladder. See photos attached.

Replace and install one Venetian blind in bedroom window

B&Q 120cm venetian blind to install on wooden frame in bedroom

The old set of wooden Venetian blinds needs to be taken down and removed (off premises by you) and a new set of similar blinds installed (which we have). They are 2cms wider than the original blinds so the old fixings need to come off and the new braces reset slightly further apart.

Blinds work fine however one of the pull strings has snapped off. It still functions fine but is missing one pull cord. I have the cord still.

The cord used to pull up and down the blind is broken and needs replacing. I have a new cord already.

I have an internal tilt and lift venetian blind where the slats have collapsed diagonally — looks like ladder cords or tilt mechanism failure. Can you repair on site, and what’s the typical cost?