Find local Mira shower repair experts in East London

My shower keeps switching between scalding hot and freezing cold… done a bit of research online, looks like it’s an issue with the Thermostatic Cartridge. Need to remove the cartridge and assess the situation, it might just need a descale. Just not really sure how. I’m guessing it’s not a huge job. If time and skills permit I’d also like to hand a couple of hooks on the wall, just not confident with a drill. Thanks.

2 new shower heads and hose removed and new ones to be installed. in the shower room the sealant around the shower needs be removed and then replaced with a new one

We have recently had our flat decorated, and new bath panels installed. Since this time, our bath taps have started leaking and we believe they need replacing. The new bath panels were tricky to install and have been cut to size etc (as in pictures), so we’d ideally like this done without the new bath panels removing. We'd like a whole new tap, shower head, waterfall shower set up (not piping behind the walls, but connected externally from the bath taps). Image of the shower we would like are attached. The shower is: Architeckt - Square Waterfall Bath Shower System Mixer Shower Tap with Modern Square Riser Rail Kit Dual Rainfall Shower Heads Handset, Black.

Greetings. We have a shower issue. Shower has come off the wall and shower head won’t stay up. Images attached. E14 9QU

I need to replace my current shower cubicle and the wall tiles around the shower cubicle area. This was only done about 8 months ago but the person did a terrible job and we can see there is a bit of leak on the kitchen ceiling which is right below our bathroom. This is definirely coming from the shower cubicle replacement we did 8 months ago. So now we are needing to fully replace the current one and also the wall tiles. The below price is for the labour only. I am looking for an experienced worker as i do not want to make the same mistake again. Please also provide gurantee for your work.

My cleaner has not turned off the shower on the Tiron, but by the shower head meaning over 8 hours the pressure release device has been triggered. Now the shower does not function and water streams from the bottom, it needs a replacement PRD fitted.

Hot water dial is a bit broken but even before that the hot water wasn’t getting hot. Other taps in the property are fine

Water pouring through the shower water escaping through some loosened pipe

Fit bath taps and shower head- see pictures below.

I have a Small wet room that I need a shower Enclousre fitted but one problem its an Electric Shower so the water trap is a Suction and will need to cut a hole on the tray to lead to the trap also Fit glass panels

Bath tap gets fully hot, but shower stays only lukewarm even with the shower head removed. Likely fault with the concealed mixer diverter or thermostatic cartridge. Looking for diagnosis and front-access repair/replacement.

1) Install bath shower system – Install a thermostatic bath shower set onto existing bath – Connect to existing hot and cold water supply – Mount shower rail securely to wall – Ensure correct water pressure and temperature control 2. Replace bath taps – Remove existing bath taps – Install new mixer tap – Connect to existing pipework and check for leaks 3. Replace bathroom sink tap – Remove current sink tap – Install mixer tap – Connect to existing pipework 4. Install new basin in separate toilet (no existing sink) – Install small basin with mixer tap – Run new hot and cold water pipework to basin – Install waste pipe and connect to drainage – Ensure everything is fully functional and leak-free General requirements: – All pipework, fittings, connectors, and fixings to be supplied/installed as needed – Ensure all installations are secure, sealed, and tested – Clean finish and proper installation required

The shower is an electric one and does not produce hot water now. It was working yesterday and now it is faulty. If someone could take a look would be grateful.

I want two Muslim showers to be installed in my house bathrooms. I would want the install to not be rubber but instead copper to avoid any leakage. Biggest problem with some cheap installs is the bad connection so they are constantly leaking, I don’t want this issue. I want copper insertions

Ive got new shower that needs fixing and little plumbing issue when I tried to fix it, price can be negotiable

Install hard water filter & shower head Help unclog bathroom drain (optional)

Want bath tap turned into a shower

Our electric shower has just randomly stopped working and need someone to come and take a look at it urgently. I’ve bought a new shower head as I initially thought the issue might have been he hose but after installing it stiill issues - need someone to coome asap - thank you

The hot water tap on my shower has stopped working properly. When I twist the hot water handle, only a very small amount of water comes out. Cold water still works normally. This started recently 2 days ago, no visible leaks. Looking for someone to inspect, repair/replace the tap or internal valve if needed.

Remove old Shower thermostat and apply new shower thermostat