Find a trusted local electrician in Manchester

Fridge Socket stopped working Wall light needs reconnecting to wall Hang pendant light from Ikea

The electric window on the drivers side goes up and down as and when it feels like it, the fuse has been disconnected, this doesn’t stop the problem. There doesn’t seem to be a problem with the actual window buttons.

My electric wall heater fell off from the wall because the bolt on the wall was weak and it fell off

I want to put a toilet and mini bath in my room. And do some electrical works ad well.

Need light fitting changing in all rooms of house, lights are from Dunhelm, also 1 socket and 1 switch changing. I have done a renovation and I am burnt out…

Want some Vertical filler panels to cover the gap between the cupboards and the cooker.

- replace 3 x ceiling light fittings - fix 1 x 55mm bathroom locks - replace 1 x broken door handles - fix down 3 x loose door thresholds - check window blinds (stuck)

I have an outdoor shed in my garden. The shed itself is plastic but i had some work done to have some wood surrounding all the walls on the floor done. I also had someone route power from the kitchen to the shed but after moving a few things around we have noticed the power has stopped working. The main things need powering a deep freezer and the light bulb. Someone with experience who can come out urgently is needed

Looking to have sockets replaced ceiling lights to replace and new gas fire replace

1. Fix the outdoor light by replacing one and add wiring for other 2. Install roof fan 3. Add electric socket from outside to inside of the cabinet.

I need advice and someone that can install a smart control system fir my water boiler

The wand inside the electric fire isnt working

New electric cooker being ordered so will need someone to connect this

Motor needs replacement, model vent axia, kinetic advance S . I already have the replacement

Install a small cooker hood above the cooker.

The old cooker extraction unit has seen better days and needs to be removed. A new unit needs to be purchased and fitted and connected to the mains (already installed) by someone who needs to ensure that the new extraction unit’s hood is 750mm from the top of the gas cooker to the bottom of the hood. and a Splashback plate to be fitted to the wall.

Replace a 16 module electricity consumer unit.

On the landing and downstairs

Simple electrical job fitting 2 X wall socket.

Need washer plumbed in and electric cooker connected.