Find a local console repairer in Central London

Fix 3 lamps to the ceiling.

I need just the steps (not risers or sides) of the inside stairs in my flat. The first set of steps goes from inside my flat entry door up to living area, and next set goes up to bedrooms. Just sand and repaint.

Lb button needs fixed on my Xbox controller

IKEA bed portion has collapsed. Needs drilling or gluing back in place. Please do not negotiate higher as I'm disabled and on low income. Possible drill or glue needed?.. I've got the screws

machine keeps turning off mid cycle - it's a beko washe dryer

Rewrite vintage Italian lamps - the fuze broke on one and the other never turned off. Bought at auction. If possible, I’d like to change to English wire, change the light bulb fixture (as currently takes R50 which doesn’t allow for warmer than 2700k) and add a dimmer onto the plug.

Fit new kitchen counter top and sink

I need someone just to go to the property and open the door

I am moving out and need two ceiling lamps taken out, and have the old ones reinstalled

Touching up some paint work

It’s a white table that needs to be mounted in the wall. The wall itself is hollow so will need it needs to be supported well.

Klepstad wardrobe assembly

Sorry this had expired before I got to respond to my offers; would like done tomorrow/ Sunday or this week. Must have experience/ qualification Change taps for bath and sink. Including waste pipe/plug. Pictures attached of new and current taps. Must be a set fee as the price cannot keep going up to get the job done or more days added on.

Inside the hdmi is broken

Assembly of an IKEA Kleppstad wardrobe with 3 doors

My bathroom taps need replacing as are dripping - I managed to change one of the cartridges myself but due to the very old Bristan parts, I can’t find a spline to extend to put the tap back on. And haven’t bothered trying with the hot tap as couldn’t complete the job myself. Believe I need to change the taps and panel entirely. It is a Bristan bath tap set which was fitted to a basin. EDIT: should have stated I do not have the parts - I have new cartridges for the dripping but need new taps and backing plate to be sourced for me please

Up button on D pad does not work

Plumping taps port swapped

Replace current intumescent strips with intumescent smoke seals on 5 internal doors.

Three garage doors in W2 2SB, have gaps at the bottom, need to add a plank at bottom of each door to fully close, the gap to avoid dust and rodents and foxes from entering. There are examples of doors that have already been fixed in this way. In this way. In thePhotos attched, there are three doors to be done and the sizes are as follows.: Here are the measurements for the 3 garages (width of the door and the gap between the closed door and floor): # 9 door: 221 cm wide, 8 cm gap # 11 door: 221.5 cm wide, 9 cm gap # 19 door: 221.5 cm, 10 cm gap People have filled the gap in 3 ways that I could see: 1. fitted wood planks on the inside or outside of the door, 2. ⁠fitted wood plank seemingly on the ground, along the door. 3. ⁠fitted rubber like material plank on the inside (or outside) of the door 1 is the most common. Would like to get this done as soon as possible. Sunday the 8th June, tomorrow would be a great time to get this done.