Find professional chimney repair services in London

Builder has opened up the inside of a chimney stack in our kitchen. The front and top area has been covered with timber. Need someone to install a 90cm extractor hood, fixing to the timber, connecting to the extraction duct. (already installed) and electrics (wiring already installed. The extractor hood is Smeg KSG9P4X 90cm Stainless Steel Canopy Cooker Hood

We need the brackets on the chimney to be raised to accommodate TV and for internet connection to be done. TV was already hung lower so bracket and wires are already there. Just need to move it up higher.

1) Removal of chimney walls from ground and 1st floor while giving support in the loft. 2) Redirect heating pipes into the wall. 3)Plaster and seal walls ready for paint. 4)Laminate flooring needs to be done after chimney removal for the small areas.

I have non-functional chimney cooker hood which needs replacing. I have purchased new cooker hood. There is an existing electrical point which can be used again for new hood.

I would like a fake chimney built above a fake fireplace which is between 2 bookshelf cabinets

Inside of chimney breast to be tiled with the green tiles pictured - including base and all sides. I’d also like a piece of white trim to be fitted along the bottom of the opening near the flooring. Negotiable on fee.

I need for my brick built bbq a cast iron door and chimney roof.

1st floor bedroom. No loft space work needed as the loft has been converted so all structural support already done. Need chimney breast removed, and make good wall with bonding and high quality plastering.

i need the old chimney cooker hood taken off and new one installed

Remove bracket from chimney breast and mount it on another chimney breast

Custom made mantel to be installed above fireplace, onto chimney breast

To apply bird spikes to chimney pot 2 story’s high. I have spikes and things to stick on with. Tasker needs to bring suitable ladder

A disused chimney space is currently 83cms in height and I need to increase it to 178cms. The depth is 56cms and the width is 96cms. The space that needs to be increased in height is mostly hollow.

Put up ikea shelf with 2 brackets on to chimney wall

TV bracket to be mounted on chimney breast and TV mounted with wiring to drop down through unused chimney and then down to the bottom side of chimney so out of sight

Re-paint through lounge walls, ceiling and woodwork white. Hang wallpaper on chimney breast. Assemble shed purchased from Amazon. One to two days work. Need completion by Friday. Already have paint and wallpaper.

Just need a quick jobs. I have a chimney made of brick. I can’t drill the holes Necessary with my hardware.

Following installation of a wood burner, the newly opened chimney breast alcove has developed a 60cm crack just above the horizontal alcove ceiling liner. Just cosmetic not structural. Possibly needs an edging strip?

Existing render has come away. Need remaining removing or stabilising. Bricks checking for movement. Rendering with appropriate mix to bond and waterproof. Waste removing. Access via ladder from roof terrace.

I need three acoustic wooden panels put up on my chimney breast. These will need to be cut from below and stuck to the wall using glue and nails (will be supplied). A cut will need to be made in one of the panels as there is a socket. Please note there are 3 long panels and I am looking for someone who have precision and attention to detail.