Find a trusted local electrician in South London

I’m fitting out a small garden prep kitchen in Coulsdon and need an experienced plumber to complete the water and waste connections. Everything is located very close together, so pipe runs are short. Scope: * connect incoming cold water supply * install hot/cold feeds to 2 sinks * connect a Flomasta 10L undersink stored water heater * fit suitable isolation valves * install the supplied pressure-relief valve and discharge arrangement in accordance with the manufacturer’s instructions * connect sink wastes and traps * connect both sink wastes into the existing waste outlet * surface-mount pipework neatly to the wall * pressure-test and check all joints for leaks The electrical connection to the water heater will be carried out separately by an electrician. I’m happy for the plumber either to supply the small plumbing materials or tell me exactly what to purchase beforehand. Please only respond if you have experience installing small unvented/stored water heaters and pressure-relief discharge pipework. Please quote a fixed labour price and indicate estimated material cost separately

Looking for an experienced Gas Safe registered heating engineer to carry out a full power flush on my central heating system. Property details: 3-bedroom detached house Approximately 8–10 radiators Potterton Promax Exclusive 35 combi boiler Boiler is over 10 years old Plate heat exchanger has been replaced twice due to suspected sludge/magnetite contamination. British Gas has advised a power flush before carrying out any further warranty repair. Please include: Full power flush of the heating system Cleaning chemicals Fresh inhibitor added on completion Cleaning of any magnetic filter (if fitted) Radiator balancing Confirmation/invoice stating a full power flush has been completed Please confirm: You are Gas Safe registered (registration number) How long the job will take Whether all chemicals and materials are included in your quote

I need a qualified electrician please to take a look at my bathroom light. Tried changing it to a spotlight and seem to have got a bit confused with wires..so now have no downstairs lights…help! Have attached a few photos but can send more if needed.

I need someone to change tube in front wheel of scooters and one rear. I have the new inner tubes but it’s complicated without tools. The make is Xiaomi M365 Pro UK Version.

Hi I need a U.K. qualified Electrician with good ratings to install two light fixtures - one dining room light and one in a downstairs toilet (light fixture and pull cord switch). Please let me know your availability on Saturday 12th September in the morning and if it’s possible to do a cheaper flat fee rather than hourly Rate. Thanks Ishan

My Thomas Sanderson Electric blind has broken in two parts- the cable to the blind and the battery pack area.

2 of our upstairs ceiling lights are not working. They are in adjacent rooms. Might be a fuse or something else. Would like someone to come and investigate and fix ideally.

Supply and Replace 4 downlighters in bedroom - currently one is working, three not working and bulbs have been replaced.

Back wheel won't turn. Throttle no power

Replacement of one double electric socket but possibly more depending on the cost.

Supply and fit a smoke alarm in the hallway on the 2nd floor - battery operated. Re-seal around a bath where there are little gaps in the sealant.

The capacitors in this Deco PX50 unit are about to blow - could someone replace them please?

Need a new extractor fan installed as old one not working

Indoor Mitsubishi air conditioning unit is leaking water into the room and needs urgent attention. Looking for a qualified engineer who can attend today or as soon as possible. Likely a blocked condensate drain or loose pipe connection, but happy for the engineer to diagnose on arrival. Domestic property, easy access to the unit. Please only get in touch if you're available to look at this today or tomorrow.

Install 3 AC units in one home- I have all the material

- Sectional concrete garage being demolished — need the electrics made safe first - Small CPN consumer unit/isolator (100A) with two MCBs mounted on garage wall - Fed by underground armoured cable (SWA) running from the main house - Need: isolate at source, disconnect board, remove it, and safely cap the cable end so it can be reconnected later (reusing the same supply for a new build on the same site) - Must be a qualified/certified electrician (NICEIC/NAPIT or equivalent) - Location: South London (Croydon/Wallington) - Need to be done on or before Wed 2nd Sept

I have an existing NEFF integrated microwave. This is hardwired into an isolator switch. I need this unit swapped out for the new NEFF microwave that I bought. I cannot do the electrics myself.

The fridge freezer LOGIK trips the electricity when turned on. Need to fix this issue

Need a outside security camera fitted

One of the switches in the fuse box keeps tripping