Find a trusted local electrician in South London

AA has already dismantled the gear selector and it jyst needs replacing

Hello Electrician I have a house share where the circuit breaker for all light circuit has flipped down and will noy return to up position. Some kind of short in circuit . The fault has caused not lights and requires an evening visit, Fusebox is accessible in hallway above head and requires a small step ladders. All check on switches and test has been done and requires a call out this evening. RCD is down and will not go up

Setting up my set up, standing desk, office chair and monitor arm

Need a electric shower installed, the plumbing is already installed and consumer unit connection already installed, just need someone qualified to connect the water supply and make the electrical connection, as a precaution you should potentially require a few plumbing fixtures incase you need to adjust the current pipe work

Installation of cooker - electric oven

Need a plug put in on a wall (opposite where one already is through a stud wall) and a downlight moved to a better position and the ceiling made good

The ceiling lights in two rooms that are adjacent have ceased working

Electrician has installed a new socket and had to make several access holes in the walls to run the cable due to timber inside the walls. Looking for someone to properly patch and plaster/fill the holes and leave the walls smooth and ready for painting. Mostly small holes, with a few longer openings - see photos. Located in Bromley/Beckenham area. No painting required, just making good and leaving a smooth finish ready to decorate.

I need an electrical plug socket put into this wall and then the tv moved from its current position, to where the new socket is. Important that no wires are showing once TV is mounted. Wall is Stud. I have a TV bracket.

- 6 pieces down light installation in kitchen -4-5 pieces wall plug socket to be checked

Handyman needed – front room installation I need an experienced handyman to complete a few jobs in the front room: * Install electric roller blinds * Install/mount a soundbar stand * Tidy and potentially conceal/hide the wires from the TV and soundbar so the setup looks clean * General drilling/fixing required for the above I already have the hardware. Should be a relatively straightforward job, around 2 hours.

Install a Fotile V10 cooker hood with 200mm external ducting. The duct needs to run through the ceiling/floor void between storeys, so part of the ceiling will need to be opened up to route the duct and then reinstated/made good afterwards.

Need cooker connected in kitchen

Need an appliance electrician to come look at my oven. The oven works well and heats up but when I open the door it trips the whole flats electricity. Happy to pay for parts as an additional cost.

Looking for an experienced Gas Safe registered heating engineer to carry out a full power flush on my central heating system. Property details: 3-bedroom detached house Approximately 8–10 radiators Potterton Promax Exclusive 35 combi boiler Boiler is over 10 years old Plate heat exchanger has been replaced twice due to suspected sludge/magnetite contamination. British Gas has advised a power flush before carrying out any further warranty repair. Please include: Full power flush of the heating system Cleaning chemicals Fresh inhibitor added on completion Cleaning of any magnetic filter (if fitted) Radiator balancing Confirmation/invoice stating a full power flush has been completed Please confirm: You are Gas Safe registered (registration number) How long the job will take Whether all chemicals and materials are included in your quote

Existing 60cm built-in gas hob needs removing and replacing with a new electriQ 60cm 4 Burner Gas on Glass Hob (EQGH6042VOL). The current hob is connected with a fixed copper gas pipe, so this may need minor alteration/reconnection to suit the new hob. The existing worktop opening measures approximately 559mm x 495mm and the new hob specifies a 560mm x 490mm cut-out. There is a built-in oven directly underneath which can be removed for access, and a standard electrical socket is already there for the hob ignition plug. Please include removal of the old hob, fitting and connecting the new hob, any minor gas pipe adjustment required, and full gas safety/leak testing. Gas Safe registered engineer required.

Kitchen ceiling light has stopped working in a flat in SW19 (Merton). The rest of the property's lights are fine and the consumer unit has not tripped. Need an electrician to fault-find the kitchen lighting circuit and fix it - could be the light fitting, the switch or a wiring fault. Weekday daytime or Saturday access can be arranged. Please confirm your call-out charge and earliest availability.

Broken switches to purchase and replace

Need to change 3 sockets

One of the switches in the fuse box keeps tripping