Hire a professional washing machine services in London

The integrated door in our washing machine and dryer does not seem to be aligned, I need someone to fix this including fixing some end panel board to look polish.

The washing machine door latch needs to be replaced. Washing machine model: IWDE126. The door latch is faulty, and currently the machine door does not close properly.

my washing machine keeps flashing everytime i press start and i’ve checked child lock and the doors and it still won’t wash

Washing machine needs fixing - won't spin, likely as water not draining properly. Done some initial investigation but now need a professional. Machine will need pulling out of its position which will be difficult. Machine: Indesit IWDD washer-dryer (7kg + 5kg) Symptoms • Won’t spin. Spin-only cycle: timer counts down but motor never engages - no sound, no attempt to turn. • Drum rotates freely by hand. • Door lock engages correctly (single click on cycle start). • No error codes displayed. Diagnostics performed so far 1. Pump filter cleared. Removed kickplate, drained via filter, found a significant plastic blockage inside. Removed it. Impeller inspected — looks intact, spins with magnetic detents (normal). 2. Spin re-tested after filter clean - still won’t spin. Empty drum, so not an imbalance issue. 3. Drain/rinse cycles confirmed pump runs - humming/whirring audible for ~30 seconds. 4. Tilt test revealed water still sloshing in drum despite pump running and filter being clear. 5. Rinse + spin cycle attempted - significant water came out via filter afterwards, confirming pump is not fully clearing the drum. Best Guess So Far Pump runs but flow is restricted. Spin is then inhibited by the pressure sensor detecting residual water (safety interlock), which explains why the motor never engages. Possible causes: 1. Blockage in the sump hose (corrugated rubber hose between drum and pump) - possibly secondary debris from the original plastic blockage. 2. Damaged impeller blades not visible from filter side. 3. Weak/failing drain pump. Not yet checked • Sump hose (would require tilting machine). • Pressure sensor / pressure chamber hose. • Motor carbon brushes

Just moved into temp accommodation, brought my washing machine here and struggling to plumb it in

i need my old washing machine taken out and the new one put in it is quite a tight space please enquire for info

In the same place as old machine

Need someone to disconnect and remove my current washing machine (very loud/faulty drum during spin) and install/connect another LG washing machine already on site. Standard connection only – water inlet, waste pipe and power. Looking for a straightforward swap-over installation.

Looking for a plumber to install a proper cold water feed valve for a washing machine. There is an existing cold water pipe in place, but it does not currently have a standard threaded outlet suitable for a washing machine hose. The job is to fit a suitable isolation valve with a 3/4" threaded connection. The waste pipe is already in place. Access is straightforward (see photo).

Washing machine belt recently replaced but moving out of position and causing a rubber smell, need someone to diagnose and fix.

Washing machine drain requires unblocking by specialist (currently causing leak into downstairs flat ). Flat is in London bridge

Received a new washing machine in my new flat need help to install it.

I need a section of the skirting board in the kitchen cut out to be able to remove the washing machine which is currently integrated so we can install a freestanding one. need the sides where it has been cut left neatly and not rough.

Hello, I need a washing machine connected, it's in a new building. The wash pipe and waste pipe. I have a few pictures to give you an idea. Please I need this task completed.

Washing machine leaking, unsure why

Washing machine SMEG WDI14 C7

washing machine door sealant replacement PROFESSIONALS ONLY I already have the part Only labour needed to fit part

Disconnect old washing machine then connect new machine

Hi, I need someone to help with a drainage problem. My washing machine isn’t draining properly and when it does drain, the dirty water backs up into the kitchen sink. There’s also stagnant water left sitting in the washing machine drum and it smells bad. I think the shared waste pipe between the sink and washing machine is blocked or draining very slowly. I need someone to inspect it, clear the blockage, and make sure the washing machine drains properly again. Ideally looking for someone affordable as it should be a quick job.

Current connector to washing machine has a slow leak (as evidenced by the limescale on pipe on the picture). The valve needs replacement, the pipe needs clearing of limescale, and the dishwasher needs reconnecting.