Hire a reliable appliance service in Staffordshire

We have a cross trainer machine that currently isn't working as the connection for the lead to insert into it has been pushed inside the cross trainer. As a result, the wire from the plug doesn't have a connection point anymore

Just moved in . Just need washing machine plumbing in

I have a walking treadmill. It currently isn’t in use because the belt needs tightening. I need someone to fix the belt issue please.

JTX Treadmill has stopped working. ER02 message on display.

Dryer turns on however does not spin the drum

Hi, I have a washing machine that needs new longer tubes to be attached to the back and secured on the tap. The old ones don’t reach the drain and tap. I don’t know how to do it myself and cannot get the pipe off in the back as it’s on too hard. I need someone strong and possibly with a big wrench in case it is stuck. If anyone is close by the B74 area who could come over anytime today or tomorrow quickly, I’d really appreciate it. I’d give you £20 cash for your service. :)

Job Description: I need a qualified tradesperson to remove an existing gas hob and electric oven and install new replacements. The current oven is hard-wired on a circuit and the new oven is a plug-in model, so the old one will need to be safely disconnected. Requirements: Gas Safe registered (essential) Electrical experience / competent person for oven disconnection Able to safely remove old hob and oven and fit new ones Details: Remove old gas hob Install new gas hob Disconnect hard-wired oven Install new plug-in oven Ensure everything is tested and safe

Fit new washing machine Tried to connect myself but water always come out of the pipe May also need extra parts to secure waste pipe to sink waste pipes .

3 years old Hisense HV603D40UK is refusing to start when pressing the power button. No error code. If I unplug it and try to start it again after 1-2 hours, it will start and do it's job. Slight vibration noise for the first 20 second after it eventually starts, no odd noise after that. I would like to have it fixed, if it makes sense financially.

Hi , I am looking for a specialist to carry out a "ductless-to-ducted" kitchen conversion in my new-build Taylor Wimpey home this February. The current setup is a recirculating Electrolux hood. I am looking for a professional "one-stop" service to vent this externally to a high standard. Technical Requirements: • Diamond Core Drilling: A clean 155mm hole needs to be drilled through the external masonry (brick/cavity/block). This must be done with a diamond core drill (no hammer/chisel) to ensure no damage to the external brick face or internal plaster. • The Ducting: I require 150mm rigid round ducting to be installed through the wall (cut to size). Please do not use flexible foil/hose through the wall cavity as I want to remain compliant with NHBC Section 8.3 standards. • Airtight External Vent: I will be providing a Naber Flow Star GTS 150 (magnetic airtight system) or Luxair automatic airtight system.This needs to be fitted to the external brickwork and sealed with silicone. • Internal Connection: My existing Electrolux hood has a 150mm outlet. I need the rigid ducting connected to the hood motor and sealed using aluminum foil tape to ensure it is 100% airtight within the chimney piece. • Weatherproofing: The duct must be installed with a slight (1–2 degree) downward pitch toward the exterior to prevent condensation or rain ingress. Project Scope: • Location: Kitchen is on an external wall (back-to-back install). • Access: Side elevation of the property. • Timing: feb Could you please confirm: 1. Do you provide the diamond core drilling as part of your service? 2. Are you comfortable installing the Naber magnetic vent system or Luxair automatic vent system 3. What is your estimated lead time and cost for this specific installation? 4. Will you guarantee that my existing MVHR system will not be impacted by the vent and will be airtight I look forward to hearing from you. Kind regards, Anam

My freezer has been making a loud noise , the noise stops when I open the freezer door everything works perfectly let me know your prise and we can work something out

washing machine leaking from left side

Treadmill was working then the following day I can switch it on but not responded

Rabbit has chewed through cable on electric recliner sofa and no longer works despite cable being repaired.

Washing machine leaking.

I have got cookology countertop dishwasher that I need someone to fit it for me

The fridge will be delivered on 20 Dec and I want a pipe laid from the mains to the ice maker in the fridge. I would like this done before they deliver fridge

Run a water from the tap to the fridge to dispense cold water and ice

Reconnect Electric cooker

I have got 2 wireless eufy security cameras that need mounting onto the front and back of my house.