Book a reliable freezer installation and repair service in Central London

AO were due to install a fridge freezer but could not do it as the skirting board was fixed. We have now removed the skirting and would like it installed. It is an integrated under counter fridge freezer.

11 doors, 1 deep freezer, 1sofa

The cooling rack/evaporator coil of the freezer has become loose. Not sure if it can be re-tightened or needs another fix

Water leaking from below freezer and now mould has formed. Would like the water to stop leaking and wood replaced and mould taken away. Thanks!

I have a large fridge freezer. I need it removed away from the wall, keeping it on a flat surface, so that the wall behind it can be inspected and dealt with. And then it needs to be put back again!

Hi there! I'm replacing my current American-style fridge freezer in my basement flat in London (postcode W2 3NA) and need experienced movers/handymen to handle the full process, as standard delivery companies can't manage the stairs or door removal. I've purchased a new LG InstaView GSGV81PYLL American-Style Smart Fridge Freezer (dimensions approx. 91.3cm wide x 179cm high x 73.5cm deep, weight around 130kg – confirm on site if needed). The delivery will be to curbside only. What I Need: Collect the new fridge from curbside outside my building. Carefully manoeuvre it down 14 external steps to the basement entrance (no lift, but space is clear). Remove the doors/panels as required to fit through the doorway (tools provided if needed, or bring your own). Position the new fridge in my kitchen (flat layout is straightforward, no internal stairs). Disconnect, remove, and dispose of/take away my old American fridge freezer (currently in kitchen; it's similar size/weight). Reconnect the new fridge (basic plug-in, no complex plumbing) and ensure it's level/stable. All work to be done safely, with care to avoid damage to the appliance, property, or yourselves – insurance and experience with heavy appliances essential. This needs to happen on 8th December. I'll coordinate the delivery timing with you once confirmed.

The base I’m using for the mini freezer needs adjustment

There is a build-up of ice on the inside of the freezer, which may be due to a loose rubber door seal. However, it could also be caused by another issue, so we would need someone to diagnose the problem and carry out the necessary repairs.

I need someone to replace the compressor start relay/overload device on my fridge freezer. It’s the small black electrical module that plugs onto the 3 pins of the compressor at the back of the fridge. I already have the replacement part that should work. The job is to remove the old relay and install the new one. It’s a Montpellier mff166k model

unable to find the off switch for the freezer, so require a steamer to defrost freezer, and also fix the integrated door that has detached.

I need someone to look into my amica fridge freezer. Water is leaking inside and things are being frozen too much

Plinth Currently, the doors of the fridge freezer doors do not line up with the doors of the cupboard. We need a plinth to be made to raise the level of the frige freezer so fridge freezer doors are level with the cup doors The fridge freezer doors can then be attached to the cupboard doors. Hinges for the cupboard We need to replace the hinges for the cupboard doors (that will be attached to the fridge freezer doors). The screws for the hinges need to be reinforced so they don’t come loose with repeated opening and closing of the fridge freezer doors. The fridge door contains heavy objects (like large bottles of milk) and that puts pressure on the hinges and screws which causes them to come loose over time so they need to be reinforced to prevent that from occuring. Also, we need 10cm cut off a door

We have a brand new Adexa freezer (commercial) that heats up instead of cooling down. We need an engineer to write a diagnostic report.

I have removed an old freezer, but it now needs to be disposed of from the property. Also, the new freezer that I’ve installed is difficult to position so that it connects to the integrated door and shuts fully. This could be solved by temporarily taking the fridge and shelf out above it to get the freezer properly aligned or possibly adding to battens inside the cabinet door so that the freezer can shut fully when attached to the door.

I have purchased a replacement integrated fridge/freezer (Ikea Isande) but I need help with reversing the hinges so it's left side opening instead of right. Once this is done, I'd like support with fitting it back into the integrated unit.

Samsung Fridge-Freezer – Fridge Not Cooling (Freezer Working Fine) Description: My Samsung fridge-freezer powers on and the freezer is working perfectly (–19°C), but the fridge compartment isn’t cooling properly. The display and compressor work, and I can hear the fan running, so the issue is likely with the air damper or temperature sensor (thermistor) that controls airflow from the freezer to the fridge. I need an experienced fridge/appliance repair technician (not an electrician) to diagnose and repair the problem. Model type: Samsung No Frost fridge-freezer (Smart Eco System, digital display on the front).

Looking to fix a Zanussi fridge/freezer which is leaking a bit of water from time to time. Likely that freezer drain needs to be released.

Freezer seal stopped working so door won’t close. Have tried hairdryer trick which has worked in the past but no luck.

I need my freezer fully defrosted so I can sell it/ replace it with the new one. I have tried to do this myself but have failed. I have attached photos below.

My fridge freezer is installed into the cupboard, i need it taken out so that i can clean the drip tray and then put back in. Thank you