Find a professional verandah installer in VIC

One of the timber posts supporting my back verandah has become loose at the bottom and needs to be properly secured again. I don’t think the post itself needs replacing. It needs to be straightened/reset and fixed securely at the base. Ideally I’d like the paver/bricks around the post lifted if needed, then a proper galvanised post anchor/base fixed into the concrete footing underneath. The verandah roof may need to be temporarily supported while the post is being secured. Please quote labour and any materials required.

Please submit a quote for below thank you. Please note that this pertains to the steel verandah structure that has been constructed over the existing deck. I require inspection and written report/certification addressing the structural adequacy of an existing verandah frame and roof, connections to existing deck, for submission to my Building Surveyor in response to a Building Notice. Including any necessary structural calculations and specify any rectification required if the existing construction cannot be certified as-is. I have an updated set of site drawings and original permit documents from Council. Attached is example of the site drawings and pictures referencing the structure in general

’m looking to build a covered outdoor area/verandah at my home in Melton. The area is approximately 9m × 2.4m (around 22m²). I have some ideas in mind, but I’m open to suggestions on the design, roof style and materials. The main aim is to create a practical covered outdoor area that looks good with the existing house and provides weather protection while still allowing good natural light. I’m considering options such as: Steel/Colorbond construction Skillion/flat roof or another suitable roof design Combination of Colorbond and clear/translucent roofing Other cost-effective options you may recommend I would prefer someone experienced with verandahs/pergolas who can advise on the best design for the space. Please let me know: Your suggested design Approximate supply & installation cost Whether engineering/drawings are included Whether you can arrange the required building permit/approvals What materials you recommend Examples/photos of similar work you have completed

External verandah needs enclosure need to build window and glass metal frame then install window glass and door.

Suggestions and quotes on how to make a verandah rainproof. Perhaps with Perspex/acrylic sheeting? Not sure. Location, Chelsea.

Ceiling board on verandah has fallen off - needs to be replaced Roller door/ sliding door in lounge is stuck and needs to be fixed

Construct a verandah frame. Posts and hockey sticks. Provide a price to provide posts, hockey sticks, curved roof sheets and to construct. Roughly 32m long and 1800mm wide.

Looking to get a insulated roof pergola/ verandah installed including council permit. 4.2 meters X 3.2 meters

Wooden post on verandah has rotted and broken, top has detached from verandah ceiling. Replacement does not have to match original decorative style, can be plain square post.

Backed into the verandah post, has been eaten by termites so its very brittle. Needs replacing.

Looking for an experienced carpenter/handyman to supply, replace damaged boards, and restore our L-shaped front verandah deck. 1. Board Replacement: Supply and install approx 16 linear metres of 80mm Jarrah decking boards to replace rotted/damaged sections. Remove and dispose of old boards. 2. Deck Clean & Restoration: Clean/prep existing and new Jarrah timber (approx. 21m² total area). Apply 3 coats of Feast Watson Black Japan finish (TBC).

Hang 2 new flywire doors (hardware provided). Install bolt locks on one door (provided) and door closer (provided) on the other door. Replace post on verandah. Replacement timber is provided. Straighten up verandah with new screws.

Looking for an experienced roofer or tradesperson to supply and install a new custom Colorbond counter-flashing for a verandah roof (approx. 7.5 to 8 meters total length). Scope of Work: - Remove and dispose of the old flashing. - Supply and install new Colorbond flashing material. - Must cut a chase/groove into the rendered brick wall using a masonry grinder to mechanically lock and tuck the flashing in properly, rather than just surface-gluing with silicone. - Apply a heavy, continuous bead of high-grade exterior polyurethane sealant. Please provide your quotes including materials, labor, and waste removal.

Knock down backyard patio that is made of wood. There are downlights and electrical, and I need the lights retained for the future build. Removal of the wood optional depending on cost. Looking to get this done after 30 August 2026. Thanks

Run down verandah needs repairing and some parts removed.

Screen has disconnected from the zipper.

Replace or re-lay broken or tiles that have come away on verandah and outdoor barbecue area.

Remove old grout and regrout a small apartment balcony. You will supply own equipment thanks. See pictures.

I have a damaged down pipe that needs to be replaced asap on my verandah so essentially you will need to supply and replace needs to be monument color

Verandah ceiling has slipped from the holding roof timber on one side of the verandah and needs to be pinned back up. The verandah is about 5m X 4m size, and the the slip on affecting the last 1/4.