Find experienced local tradies in SA

We have a door way we need framed out and gyprocked, and a new doorway cutout and gyprocked around and the skirting

Need an outdoor fan installed in our alfresco and an exterior power point installed

The room was originally a bathroom. However, when I purchased the property, it had sustained water damage, so I removed the existing wall linings to allow for a fresh start. The required works are: Reinstate one wall with a new timber frame. Install new plasterboard to the walls and ceiling, ready for waterproofing and tiling. Prepare the surfaces for tiling. Retain all existing plumbing and services in their original locations. Materials: I already have the timber required for the framing. I will be purchasing and supplying the tiles. The intention is to reinstate the bathroom using the existing layout and service locations.

Remove peeling paint, prep the cement surface then paint with no slip product/paint

I have two outdoor awning blinds that have the rods left and right. The blinds come down but are floppy and do not roll out. They are newish 2-3 years old. I need help to make them work

I’ve got several holes in plasterboard walls at a rental in Huntfield Heights. Can I send you photos for a fixed quote to patch them all and sand them ready for paint? What’s the earliest you could fit it in, even if you get a cancellation?”

Supply and install black stainless steel round post and handrail with stainless steel wire rope according to drawings attached

I am looking for a quote with a qualified electrician to install a 10 amp single phase power point outdoors. Also a safety switch installed indoors.

Help with flat-packed sauna installs around Adelaide. Mainly helping unload, carry panels in and assist with assembly. Looking for someone reliable and fit. Potential for ongoing work.

Looking for an experienced TV and home theatre installer to complete installation work in my newly built townhouse in West Lakes, Adelaide. 1. Mount 2x 65-inch Hisense TVs TV model: Hisense 65U7SAU ULED Mini-LED 4K * One TV in the upstairs master bedroom. * One TV in the downstairs bedroom. * I already have 2x SANUS Advanced Tilt 4D Premium TV Wall Mounts (model VLT7-B2). * These are premium adjustable mounts with tilt, swivel and extension functionality, suitable for TVs up to 90 inches. * Mount both TVs securely at an appropriate viewing height. * Conceal all visible cabling where practical for a clean, professional finish. 2. Install 2x additional power points * Install one new power point behind each bedroom TV. * Power points should be positioned so they are completely concealed once the TVs are mounted. * Electrical installation must be completed by a licensed electrician. 3. Install Samsung home theatre system Model: Samsung HW-Q990H/XY Q-Series 11.1.4 Channel Dolby Atmos Soundbar System (2026). The system includes: * Main soundbar * 2x wireless rear surround speakers * Wireless subwoofer Installation required: * Wall-mount the main soundbar in the living room. * Wall-mount both rear surround speakers in suitable positions. * Position and connect the subwoofer. * Conceal power cables where practical. * Connect and configure the complete home theatre system. Please note that the rear speakers are wireless for audio but still require power connections. Additional information All TVs, wall-mounting brackets and home theatre equipment have already been purchased. I’m after a professional installation with minimal visible cables and no unnecessary damage to the walls. Ideally looking for someone who can complete the TV and speaker installation and arrange the required electrical work. Please provide a quote for the complete job and advise whether electrical work is included. Location: West Lakes, Adelaide SA.

Metal frame house patch and repair urgently to wall. Measurements approximately 7.5cm top crack across to 11cm. Price to include paint touch up so it is not obvious that it was repaired as this is a rental.

Bricklayer needed – rebuild pillar in Gawler Looking for an experienced bricklayer to build a new brick pillar to match an existing pillar. The concrete footing has already been poured, and I’ll handle the rendering once the brickwork is complete. The existing pillar is approximately 1.6 m high and 370 mm deep. The new pillar will be around 500 mm wide. I can provide photos and confirm the final dimensions on site. Please let me know your availability, price, and whether your quote includes supplying the bricks and mortar.

The outdoor garden tap has broken off at the wall. The brass tap body is intact, but it was threaded into a plastic/poly wall fitting that snapped cleanly at the collar—the sheared threaded ring is still on the tap threads. I have disconnected the irrigation/hose water from another point for now.

Damaged plasterboard wall needs repair work. No paintwork required just plasterboard.

Looking for a plasterer to repair several cracks in a plasterboard ceiling around a downlight. Some cracking has opened up and will likely need proper patching and re-setting rather than a simple fill. Please provide a quote and availability. Photos attached. Looking for a neat, professional finish ready for painting.

Need around 20 powerpoints and maybe 10 light switches changed to new ones. Add one data point. I'll supply the sockets and switches. Some of these may go into new locations, I ill rough in the wiring and leave ends exposed for you. Need to degas and remove split system aircon.

I need a built in wardrobe removed

Damage to ceiling gyprock due to an accident several months ago. Scope of work needed: Remove the protective sheeting. Prepare and Clean the ceiling framing. Supply and Install new 10 mm thick ceiling grade plasterboard in approx. 12 m2. Cut holes x 3 for ceiling downlights into new gyprock sheet. Back block edge joints. Fill, Tape and Flush the abutting edges. Sand over the applied fillers ready for painting.

Repair some nail holes make surface good and paint over (supplied) Paint one wall, repair minor damage to two internal doors, make good and paint.

Plumbing required to lower vanity tap and washing machine taps lower so that a new vanity and laundry bench can be installed , will need someone who can cut out gyprock to get to the pipes and then patch up . Need to supply and install washing machine valve and connect to washing machine.After a new laundry sink is installed will need to connect sink and new mixer tap.