Find trusted mechanics in Melbourne

I replaced the clutch and im having trouble bleeding it i need help

My vfr750 is having drag when change to first it makes loud noise when change into gears and is very hard to get out of first or find neutral

Vfr750 1994 rc36 2. Changed clutch plates and springs and clutch slave cylinder and now I can get the bike to stop dragging forward or change into gears properly

Need a bullbar fitted onto my 2021 Hilux gun 126r sr

Timing belt replacement Hyundai tuscon 2005 2.7 L engine . Would like water pump , tensioners / idlers and cam/crank seals done too. If drive belt can be included also, please specify.

I require a mechanic to drain and replace transmission fluid with correct type. And a general service and potential speed sensors replacement on Volvo

I have a Holden Cruze Equipe 2015. I previously had an 11inch screen installed but I don’t like it anymore as it doesn’t have Apple Car Play. I have purchased a new 9 inch screen and I need someone to install It

Mazda3 2008 Oil and filter provided

Ford FG 2008 sedan Front Brake pads supplied, just need to remove old ones and install new ones. Can drive to your place too Edit; possibly have a look at brake booster for adjustment of a certain part to prevent steering wheel shake during de-acceleration / braking

Looking for someone experienced to install a bullbar onsite for my 2018 Nissan Navara NP300. Bullbar already supplied and I also have all hardware, brackets and bolts ready. Please let me know: - Your pricing - Availability - Experience with Navara/bullbar installs Located in coburg

Need the engine oil changed in my Subaru Brumby.

I want someone to replace my honda grom clutch

I am buying a head unit from Aliexpress for my 2006 honda accord. Need to install it along with the camera and ADAS DVR.

I need someone to come and change the oil and filter of my car I drive a peugeot 2008 2017 model

Looking for an experienced mechanic or qualified person to replace the brake pads on my 2022 Volkswagen Tiguan Allspace. I already have the new brake pads and grease ready to go. The job is purely installation – I just don’t have the required tools or the rear brake release equipment/technology to complete it myself. Details: * Vehicle: 2022 VW Tiguan Allspace * Parts supplied: Yes (brake pads + grease) * Work required: Remove old pads and install new ones (front and rear) * Note: Rear brakes require proper electronic release/reset

Need experienced mechanic service 2 cars – must follow exact oil change method. Oil and filters Supplied Description: Looking for someone to do an oil and filter service on 2 cars. This is not just a normal quick oil change. I want the job done exactly to a specific method step by step, so I need someone who is careful, patient, mechanically minded, and happy to follow instructions properly. Please only apply if you’re confident doing the below exactly as requested: Required oil change procedure: 1. Start with the engine completely cold. 2. Add about 1 litre / 1 quart of fresh oil to the existing oil as a pre-flush. 3. Start engine and let it idle for exactly 5 minutes. 4. Turn engine off and wait 10 minutes. 5. Then drive the car 10–15 minutes to full operating temperature. 6. Park on level ground, let it idle 2 more minutes, then drain the oil immediately while hot. 7. After the first drain, leave it for 30 minutes, then remove the drain plug again and do a second drain. 8. Fit new oil filter, but pre-fill the filter to about 60–70% with fresh oil first. 9. Apply a thin film of oil to the rubber gasket and hand tighten only. 10. Refill engine slowly with about 80% of oil capacity first. 11. Wait 5 minutes, then top up slowly in small amounts, checking the dipstick each time. 12. Final oil level should be around halfway between low and full, not overfilled. 13. After refilling, do not start the engine straight away. 14. Turn ignition on without starting, wait 10 seconds, then turn it off. 15. Repeat that 3 times. 16. Then start engine and let it idle for exactly 3 minutes without touching the accelerator. 17. Check for oil leaks around drain plug and filter. 18. Turn engine off, wait 2 minutes, then re-check oil level and top up if needed. Must Have • has experience servicing cars, or is very mechanically capable • has their own tools • works cleanly and carefully • is happy to follow this exact process, not their usual rushed method

Just regas of a 2014 Holden Commodore. Flexible with times, preferably over the next 5 days. Onsite or st kilda area

Need an oil and oil filter change. I can supply oil and filter.

AC needs regassing as accidentally unscrewed it and broke the O-ring

The car is shaking when I try to accelerate and needs spark plug and ignition coil (quantity unknown) replacement.