Find an experienced handyman in West Perth

Install a 1200mm long, 100mm wide piece of 10mm glass shelf in our shower using 4 x Hafele clips: (https://www.hafele.com.au/en/product/shelf-support-with-tightening-clamps-for-wood-and-glass/P-00862112/) Careful drilling will be required into the existing ceramic tiled walls for the 4 x fixing points. Installer to provide appropriate fixings.

I have 2 blinds that are stuck and won’t pull up

The Kitchen sink cupboard top needs repair. The size of the worn laminate are approx 65mm x 40mm each. I just need it touched up to look presentable. As this is a rental unit.

fix 3 piece drawers, the slide motion has broken, Assemble kids bed frame , 🛏️ Fix a few locks on doors.

Colour match with wardrobe carpet. Need underlay. Urgent. Access anytime.

Drill holes on brick for the cutain rods.

I’m looking for a quality ceiling repair, I have 3x holes of 40x40cm which need to be fixed and patched (no need for painting). I have the 3x cuts on hand.

External rendering about 3sqm, textured - to be as close to existing render as possible, open to suggestions. I will paint after.

Putting Dyson on wall plus other tasks in my office

My shower screen has few cracks and has to be replaced. Please provide quotes for glass replacement. Let me know if you need any information. Thanks. Glass height - 71/72 inch approx Width - 28/29 inch approx

Looking to install wire balastrade from Bunnings on three brick walls.

Report fly blind in a bedroom

Drill,in screws to secure Metal fly screen And Drill curtain hooks into brick wall - will need hammer drill

The cord has come off the roller on the blind, which is ~7m above the ground

Looking for a really good handyman who I can call upon when I need them to check on some of my properties. Currently need someone to look at a washing machine installation as I don’t think it was done properly. Some bolts may need to be removed.

Absco Ezislider Shed 15081 EZK assembly required. I started to try do this on my own but do not have the tools (or the know how frankly!). So a couple of pieces have been assembled together already but I’m not sure if I have even done that correctly so prob needs to be started from scratch. I have the instructions & all parts obviously. It is to be placed on top of pavers, not a concrete slab so I understand that might be less than perfectly flat. $250 in West Perth.

I have a new stud wall that will be installed and needs gyprocking approximately 3.2 m by 3 m. Also a small stud wall 1.2 m high by around 1 and 1/2 m long.

Small break on the wall. Need to be fixed by 5th Jan.

Freedom sofa that has a bottom drawer that pulls out into making the couch bigger. Missing some screws and one bracket has fallen off while the other bracket appears a bit bent. Need the bottom piece reattached so it’s not floating away when pulled out (currently completely detached)

Repair a Hunter Douglas roller blind that won’t go back up .. too tight on chain to move it up .. only goes down. 2.6 wide x 2.4m drop