Find a professional internal door contractor in Melbourne

I need an internal door hung. It will require new gold 100mm x 100mm hinges and screws. Otherwise it’s ready to go.

Need internal doors at property refurbished before painters start on Monday. 4 x internal doors shaved down 6 x cupboards doors rehung on new hinges 10 x internal doors rehung on new hinges 6 x leversets replaced 4 x privacy leversets replaced Install 6 x new cupboard handles All fixtures supplied.

Remove both doors from hinges (no disposal required). Please bring the necessary tools/equipment. Flexible with timing but preferably today

I have an internal door that is slightly too high. I need a few cm's cut off the top and help to hang it again.

Two internal doors - normal, timber swinging doors for bedrooms - dont close properly. One hits the top frame like it’s too high, the other doesn’t click close. Might be alignment issues.

Reverse two internal doors from left hanging to right and one from right hanging to left in apartment.

Install internal door and hardware.. Door is 820mm wide and needs to be trimmed down to about 805mm

I have a compartment in my unit where my fridge is located - as you can see the door has completely come off, including three of the four hinges (the backing for the top one is still attached to the board). The three hinges are still attached to the door - I'm looking for someone who can get the door reattached to the panel. Happy to cover the cost of new hinges if needed.

I’m looking for an experienced handyman or carpenter to replace an internal door in an old building. The current door is damaged and needs swapping out for a new one. I need someone who can: Assess whether the current door frame can be kept or needs replacing Remove the existing door Trim and fit a new internal door (must be sourced by you) Fit existing hardware or advise on updated hinges/latch if needed Ensure smooth operation and clean finish Minimise gaps as it is a kitchen in a commercial space and we're looking to minimise food smells. The building is older, so the frame won't be perfectly square - experience working with this is important.

Task: Fix 3 internal doors that won’t close — they are sticking at the top. Action Needed: Adjust or plane the doors or whatever else they need so they close properly.

I need a door installed in a slightly (by a couple of centimetres) non-standard sized existing door frame between two rooms in my house. Ideally would like someone to supply door/hardware and install together. I have some aesthetic preferences as to door and hardware.

I need 2 doors fitted. I have the doors here just need them installed on a bedroom and bathroom.

Please replace 2 internal doors with solid doors and fixings to make the bedrooms sound proof

Finish plastering around the door jamb

Need someone to cut 2 internal doors (35mm) following a pattern, to install cat doors.

Looking for someone to repair a hole in a standard internal hollow-core door. One side has a medium-sized hole (approx. 15cm), and the other side has visible cracks from the same impact. I’d like the door patched and repainted to match as closely as possible. Photo of both sides attached for reference. Ideally looking for someone who can do a neat job this week. Location: Southbank Flexible with timing. Thanks!

Install door hardware on 6 internal doors. All old hardware has been removed. As most of these doors are old and may need to be filled where old hardware was removed from, before replacing with new hardware. One door is new.

I broke a door in my house and need it replaced please see picture below.

This weekend, it must be done. The current door needs to be removed. The new door will need the hole cut for the handle, as well as existing hinges attached to it. I am happy to pick up the door from Hardware. I am also interested in someone who can help with painting this new door and 4 other internal doors, and their door frames, as well as the inside of external door.

I need someone to come measure my door frame (there's another door attached to a different room if you need to measure that for reference as well). The door is of custom size, approximately 218x82 cm and made of honeycomb core (you can honestly use any core you can procure easiest for you as long as it's appropriate and of similar quality). I'm going to provide the door handle and latch but please make sure the door is drilled and hollowed at the correct spots for the installation. Please mention the time estimate for your work when putting an offer. Also, if you're also able to have the door delivered and installed in already painted condition (same colour as other door), please mention in your offer and state how much you're charging.