Find a local floor sanding profesional in VIC

I’m looking for someone experienced to sand and oil my timber deck and replace/re-do screws on approximately half of the deck. Deck size: 7m x 4.4m (approx. 30.8m²) Work required: * Sand the entire deck (7m x 4.4m) * Prepare the timber properly for oiling, including removing/levelling any rough or weathered areas * Supply and apply a suitable quality decking oil (please specify the product you intend to use in your quote) * Re-screw approximately half of the deck — area is 3.7m x 4.4m (approx. 16.3m²) * Replace any damaged/stripped screws and ensure boards are securely fixed * Clean up and remove all sanding/decking waste on completion Please quote for labour + materials, including screws and decking oil. I’m looking for someone experienced with timber decking who can do a neat, professional job. Please include your availability and estimated time required. Photos can be provided/are attached

Needing our outdoor deck sanded so we can re varnish it.

Looking to extend current Tasmanian oak floors. Kitchen is currently tiled (I’ll be removing tiles) and extended the wood into kitchen area. Plus extend into a small powder room. Finished with whitewash entire downstairs area. Floor plan attached - red is rough current tiled area. Blue is area it needs to be extended to.

Interior state case with 14 timber steps, to be sanded to raw timber, then apply varnish. I’m happy to provide the varnish

Looking for someone experienced to sand back and re-stain our outdoor timber deck. The deck needs a good refresh, including proper preparation, sanding and application of a new stain to bring it back to looking fresh and well-finished. Ideally looking for someone with experience in deck restoration who can achieve a neat, professional finish.

The deck is 3x7m I am providing previous and current condition photos for reference.

Entry, Main bedroom Kitchen, dining, lounge study & family room. Approx 115 sqm Entry & kitchen bedroom areas have no stain on floor boards as tiles & carpet have been pulled up. We will also need to source small timber pieces for replacing approximately 6-8 duct holes. Photos to come. Thanks Just an update. We have water marks in the timber from underneath the tiles we have ripped up. We are getting advice to remove the water stains. Please be patient while we sort this out. Thanks Lisa

Wooden floors in kitchen need sanding and polishing. Approximately 2 mtr x 3 mtr.

Sanding 14 stairs on the stair case And staining them I have the clear stain already

Sanding and re-staining 4.5x 12 m deck! Open to quotes for sanding and restaining or just sanding! Just the decking on the ground - no need for the walls to be done ! - please note budget I just had to pop something in open to offers

Looking for an experienced floor sander to sand and finish the original Tassie Oak floorboards in two bedrooms, combined area ~25m² max. Boards are narrow, 63mm width. Scope: Full sand of existing timber floorboards (both rooms) 2–3 coat polyurethane finish (satin or semi-gloss, happy to discuss on the day) Minor gap filling if needed as part of standard prep Floors are in reasonable condition — some surface scratches and a bit of edge staining near the skirtings, no major cupping or movement.

Need our Deck revitalised. Sanding, staining, the whole box and dice! Currently looking a bit sad. Need an expert to make it look beautiful again for Spring 🌱. Approx 7.3m X 5.5m + steps.

Thorough sanding required as Decks severely weather beaten One Timber Deck at rear of house measuring 4.0m x 3.0m and a landing timber deck area near Porch Entry measuring 8-10 sqm. Total area nearly 30 sqm Thorough and Good sanding and preparation is a MUST. We want only Merbu Stain AND at least 3 coats applied as current coatings worn out. Please include all materials including cleaning solution, sand paper, Cabot Merbu stain, all applicators, protective cutting tapes etc etc in your quote

Looking for offers on sanding 28m2 of blackbutt cover grade flooring. Sanding and clear seal - no staining. The flooring isn't done yet but this is the next job that will need doing afterwards. Please ask if you need more information. I can be on site to help carry equipment up/down stairs (1 floor.

Floor sanding of Tasmanian oak. Approx 10m2. It's to level the replacement boards to the old. Hybrid flooring is going on top. It's 4 sections.

Timber floor (about 40m2) needs sanding and resurfacing.

3 bed rooms, one living room and one corridor wooden floorboards. Looking for sanding and polishing please

Task: Floorboard Prep Sanding & Polishing Brief description: Lightly sand, prepare (take out any random staples/leftover nails from carpet removal if any, fill any cracks or holes), and polish floorboards of 3/4 of a house (see floor plan red circle area). Please apply x3 coats of polyurethane as per usual standard. Details: • Location: Doncaster • Access: Easy driveway access, single story, no furniture or obstacles • Tools/materials: You’ll need your own tools and products for prepping, sanding, polishing. Scope: • 3/4 of house (see picture floorplan) • Vacuum/clear up sanding dust before polishing Timing: Around 12 - 21 June. Please quote your total price and confirm availability around 12 - 21 June. Experience with similar timber floor jobs required.

We sanded our floors and now have to sand back the railings in our stairs. We plan on painting them white. We are in Eltham

Hi I need some floor sanding quotes, only for sanding (only) please. The floors are in good condition but old and yellowed. It’s a tiny house (70 m2) … small kitchen & lounge, 3 bedrooms & hallway, that’s all. Will attach pics. Needs done asap. I am a painter so I can do the two coats of clear on top, so this part is not required. Your best daily rate please!!