Find experienced local fencing contractors in Ashburton

Supply and Install 1.8lm of paling fencing to match/ tie in to existing fence and the garage. Include all material and footings to complete task Power on site

Hi, I am looking for a professional fencer to replace the fencing on my corner block property in Ashburton (VIC 3147). 1. Demolition & Disposal (Must Include) Demolish: Remove the existing low brick wall on the side boundary and the old fence on the front boundary. Disposal: You must remove all waste, including all bricks and green waste, from the site. 2. Supply & Installation Style: Picket Fence (approx. 1.0m height to comply with corner regulations). Finish: Must be painted/stained in Charcoal (or pre-finished material). Measurements: Front: approx. 16.63m Side (Mernda Ave): approx. 12.26m Gate: approx. 2.66m wide (Vehicle access) - Style to match the fence. Total Length: approx. 31.55m (including gate). Requirements: All-Inclusive Quote: Price must include All Materials (fence, posts, gate, hardware, paint), Labour, and Disposal fees (especially for bricks). Insurance: Preference will be given to taskers with valid Public Liability Insurance. Site Details: Corner block, easy street access. Please see attached photos for the current brick wall condition and measurements. Please provide a quote covering the full scope of work. Thank you.

Plants has damaged the fence, need fix the fence and cut some plants if needed

quotes only 38m Palings Fence Repair - just hammer or nail them back in quotes only just off Burke and the Monash. Iris Rd, Glen Iris 3146

18+35 2 sections of fencing need to be done. Sleeper at the bottom serve as retaining wall. Please come on site to inspect and quote.

4 x fence extension to be installed to wooden fence. Fence extensions supplied just need installation

Replace and paint 2.1m section of fence: - fence post - top and bottom rails - front skirting board - 22 windsor pickets I need to check if I have the paint at home.

Looking for a reliable labourer/handyman to carefully dismantle and remove an existing 15-metre timber paling fence and side gate The fence is in good condition and will be repurposed, so care must be taken when taking it down (no breaking or cutting of posts/palings). Details: -Approximately 15 metres long with a small side gate. -Standard timber paling fence -Posts need to be dug out and kept intact No disposal required – fence to be delivered to Northcote Requirements: -Own tools (crowbar, shovel, saw, etc.) -Experience with fence removal preferred -Careful handling of timber to ensure it can be reused

I need 4 bays of timber paling fence cut down, removed and disposed off site. Then stand the temp fence which is on site in its place. Jobs in Ashburton.

Repair glass pool gate which has dropped and not closing by itself properly

Resecure section of fence that has been pushed over

New boundary fence required to be built between two properties.

Looking for innovative flexible rubber padding on the bottom of the gate to fill the gape due to slope We have a escape artist Husky dog to stop sneaking or running away.

Please put up a 4 posts at a height of 3.3 metre & 4 pools at a length of 3.5 metre that meet at a right angel (see pitcture example). The other phot is where this will go. Coming off the house they will come off the wall and above the awning (shown in the pictures. There will be 4 of them evenly across the top of the awning. We would like the posts to be concreted in and the poles very securely attached to the house please. Presume you would use treated pine & primed ready for us to paint - my budget is inclduign the materials and your labour to finish the profit. thank you.

Remove fence and take away wooden planks

We have an existing wooden retaining wall which needs repairing. I'm seeking a general handyman to assist me. It’s not large or high. I have already dismantled most of the area needing repair and have purchased steel posts, the necessary wooden planks, and concrete to set the posts. One of the issues is that the existing posts that were holding used to support the existing wooden planks were deteriorated/rotten. However as I tried to remove them I was only able to get so much of them dug out. I’m seeking someone to come and help me finish off the job by removing the remaining material from the two post holes I have dug, removing the final post then setting the posts into concrete.

I need a quote for new fence/gate installation. Please measure and quote. Thanks

We need to install a steel fence around our bin area to enclose the area. This fence needs to be able to open up to take out the bins for the bin company to empty them and for security needs to have a latch to install a padlock.

I am looking to install a new front fence for my property and would appreciate a quotation. The design I have in mind is similar to the attached reference photo, including a central gate with an arched entrance. The dimensions are as follows: Left side width: 1,663 cm Right side width: 1,226 cm Gate width: 266 cm Fence height: Approximately 1,600 cm Additionally, the existing brick fence at the property will need to be removed as part of this project. Please provide an estimate for materials, installation, removal of the current fence, and any other relevant costs. I would also appreciate details on the timeline for completion and your recommendations for durable materials suited to Australian weather conditions. Thank you, and I look forward to your response. Kind regards,

Pool fence and possibly gate needs adjustment to retain compliance permit. Looking for someone experienced in adjusting and aligning pool fencing.