Find experienced local fencing contractors in Ashburton

Pls see photo I need the fence straighten up.

Base boards of this rear fence need replacing. The fence is around 8.17m wide. Somme look like they might be rotting.

I have three x 2400 fence extensions which I would like added to my fence. Please provide quotes.

Our fence door broke off in really bad winds. Needs new wood base and fix to new wood post.

6lm @ 1.2m high Colourbond fence 4lm @ of 1.8m high Colourbond fence 2 x 2 m tall gates @1m wide All fences and gates with 65mm posts, rails, handles, locks, sheets, concrete and fixings in monument. All Labour and materials to be included as well as rubbish removal. Sheet type in drawings.

Need help either repairing or replacing the latch on my gate as the gate has moved and it doesn’t latch properly, so the gate swings open. Might need to replace with a different latch so need help figuring out the best latch if so.

1. Reposition Existing Steel Gate Remove existing steel swing gate Relocate gate forward so it butts flush with newly rendered masonry column Relocate the steel gate post on the opposite side to suit new alignment Install new concrete footing as required Re-hang, square, and align gate for smooth operation 2. Install Steel Fence Infill Panels Install existing steel fence panels between rendered masonry piers Panels may require cutting / trimming to size Securely fix panels to masonry/rendered piers (chemical anchors or equivalent) Touch-up paint to any cut or modified areas 3. Cut Driveway & Install Conduit Saw-cut driveway to install conduit for gate motor cabling Install conduit and make good driveway surface (concrete or asphalt patch as appropriate) 4. Reinstall Automatic Gate Motor & Commission Reinstall existing automatic gate motor/unit Reconnect cabling Set limits and align motor geometry Test full operation, safety and remotes Gate must open/close smoothly and reliably Inclusions Required ✔ All labour ✔ All materials (concrete, fixings, anchors, conduit, patch materials, consumables) ✔ Cutting, drilling, welding if required ✔ Alignment and commissioning ✔ Site clean-up ✔ GST included in price

Supply and Install 1.8lm of paling fencing to match/ tie in to existing fence and the garage. Include all material and footings to complete task Power on site

Hi, I am looking for a professional fencer to replace the fencing on my corner block property in Ashburton (VIC 3147). 1. Demolition & Disposal (Must Include) Demolish: Remove the existing low brick wall on the side boundary and the old fence on the front boundary. Disposal: You must remove all waste, including all bricks and green waste, from the site. 2. Supply & Installation Style: Picket Fence (approx. 1.0m height to comply with corner regulations). Finish: Must be painted/stained in Charcoal (or pre-finished material). Measurements: Front: approx. 16.63m Side (Mernda Ave): approx. 12.26m Gate: approx. 2.66m wide (Vehicle access) - Style to match the fence. Total Length: approx. 31.55m (including gate). Requirements: All-Inclusive Quote: Price must include All Materials (fence, posts, gate, hardware, paint), Labour, and Disposal fees (especially for bricks). Insurance: Preference will be given to taskers with valid Public Liability Insurance. Site Details: Corner block, easy street access. Please see attached photos for the current brick wall condition and measurements. Please provide a quote covering the full scope of work. Thank you.

Plants has damaged the fence, need fix the fence and cut some plants if needed

quotes only 38m Palings Fence Repair - just hammer or nail them back in quotes only just off Burke and the Monash. Iris Rd, Glen Iris 3146

18+35 2 sections of fencing need to be done. Sleeper at the bottom serve as retaining wall. Please come on site to inspect and quote.

4 x fence extension to be installed to wooden fence. Fence extensions supplied just need installation

Replace and paint 2.1m section of fence: - fence post - top and bottom rails - front skirting board - 22 windsor pickets I need to check if I have the paint at home.

Looking for a reliable labourer/handyman to carefully dismantle and remove an existing 15-metre timber paling fence and side gate The fence is in good condition and will be repurposed, so care must be taken when taking it down (no breaking or cutting of posts/palings). Details: -Approximately 15 metres long with a small side gate. -Standard timber paling fence -Posts need to be dug out and kept intact No disposal required – fence to be delivered to Northcote Requirements: -Own tools (crowbar, shovel, saw, etc.) -Experience with fence removal preferred -Careful handling of timber to ensure it can be reused

I need 4 bays of timber paling fence cut down, removed and disposed off site. Then stand the temp fence which is on site in its place. Jobs in Ashburton.

Repair glass pool gate which has dropped and not closing by itself properly

Resecure section of fence that has been pushed over

New boundary fence required to be built between two properties.

Looking for innovative flexible rubber padding on the bottom of the gate to fill the gape due to slope We have a escape artist Husky dog to stop sneaking or running away.