Find trusted local electricians in South West Perth

I have purchased a 3.6 kW split-system air conditioner. I am planning to install the outdoor unit on the wall about 1 metre to the right of the back side of the indoor unit location. I would like to know the installation cost and the available installation dates.

Need outdoor power point installed around side of house

Outdoor light switches and fan not working Have checked trip switch

May be a fan and 7 Lights including kitchen light and hall way pendant light, run a electrical congute under the concrete less than 2m.

Looking for an electrician to replace 1 x expired hardwired smoke alarm

Need a double power point installed at my mothers home urgently for oxygen tank and hospital bed. She is being released tomorrow and have just been informed that we can not use a multi board.

We have a small square panel (approx 40cm x 40cm), which simply needs to be bolted onto a metal pole, with support legs surrounding. Simple assembly job, but very expensive and important piece of equipment. Nothing technical but unable to get to all 10 locations myself as these devices are required across every state in Australia. Open to recommendations and any connections in other states. Activities to be completed are: 1. Travel to the Port/ address 2. Assemble a TV Antenna ground stand (15-20 mins) 3. Bolt on a plate to the top of the TV antenna stand (10 mins) 4. Bolt on a flat IoT device (5 mins) 5. Wake the device with the back of a screwdriver - instructions to follow (5 mins) 6. Place bessa blocks / safety bollards from Bunnings to secure equipment to floor mat (delivered to site) Specific diagrams and instructions will be provided upon acceptance. Estimated task date is one of the following (TBC based on parts delivery confirmation): 23/29/30/31 Dec.

Panasonic air con is leaking. I have changed filters and vacuumed out discharge pipe but still leaning so we can’t run unit.

The is working but scrap due to work with electrical power, 1.3 Tone. Need to cut and separate bricks bank's.

Need 2 hard wired smoke alarms also certificate for RCD for house sale

Qualified electrical contractor Needed – Small Residential Jobs (Palmyra) Hi there, I’m looking for a licensed electrician to complete a few small residential tasks: Scope of Works • Install 2 × DC ceiling fans Product: Condor 136cm DC Fan (link provided: beaconlighting.com.au/condor-136cm-dc-fan-in-koa) • Replace 2 × external flood lights Existing units are broken and need a like-for-like swap. • Remove Foxtel wall conduit (Remove and make safe – no patching required.) • Install 2 × wall sconces To be installed on a double-brick external-facing wall. Product pictured and ready onsite. Details • Single-storey home • Only the primary fittings/products listed above will be supplied (Electrician to supply all wiring, connectors, screws, fixings, etc.) • Flexible with timing (ideally in the next 1–2 weeks) • Must be a qualified electrician with appropriate licences and insurance Please quote for above, and feel free to reach out with any questions. Thanks! 😊

I have two PowerPoints right next to each other. I need one only - moved about 30cm

Remove pendant and put down light

We are needing 2 double outdoor power points, and one double power point in the garage. House is a low storey brick house.

Needing 4 standard light fittings swapped out with new fittings I bought including 2 x up and down lights and 2 x small twin spotlights. These will go at the front of the house. 1 standard light fittings swapped out with a downlight to the ceiling at the entrance of house. (I have the downlight) I also require a new dimmer switch installed to my hallway as the lights are flickering bad or don’t come on at all.

I have the LEDs and base plugs. I just need an electrician to replace the 4 old LEDs with the new ones. Each new LED gets connected to a base plug.

Replace existing GPOs and Switches throughout the house. Circa 30 of them in total. i want to install the Vynco urban range from Beacon. Install will include a Fascia ontop to give a glassy finish. thanks

1 - remove and relocate marked power point to new location as marked to power new power point near vanity, a second power point in one shaver cabinet, a power source for the two shaver cabinet in the bathroom and a third for the ensuite shaver cabinet that backs onto the bathroom. 2 - replace the light switch in the main bath

I’m needing housing electrical to be disconnect by a licensed electrician 2x Lights and corresponding light switches disconnected 1x PowerPoint

Need new NBN wall socket's replaced in my house.