Find trusted local electricians in Parramatta

Require a 16amp circuits fitted off in switchboard for my new airconditioner Cable has been pre run Will need single pole enclosure and rcd

I’m looking for a qualified and experienced air conditioning technician to: • Diagnose and fix a water leak coming from my split system indoor unit • Carry out a full service of the system • Service and inspect both indoor and outdoor units • Check refrigerant/gas levels and overall system performance Please note: the unit was recently cleaned as part of an end of lease clean. While servicing, both the indoor and outdoor units must be kept clean and maintained in their current condition. No mess or additional dirt should be left behind. Please bring all required tools and equipment.

Provide and install downlights. 6 in one bedroom and 4 in another bedroom

There is an existing power point (double outlet) in the kitchen that I would like its cover to be replaced with a new one. I have the new one with me.

Need licenced electrcian to connect a 32Amp CB to Mains board. 4mm 2C+E already run to isolator. In Newington.

1) AC is stopping at times while running with the red light blinking 2) Also, water is coming out of the indoor unit sometimes. Please give me the quote

2 month old Rinnai hot water system stopped working for 3 days now. Need an Electrician level 2 to investigate any electrical issues.

Require supply and installation of light switch, 2 x downlights and 2 power points in bathroom. Installation of light/heat/fan unit, which will be supplied by client.

Need to procure and install 2 X outdoor power points 3 X indoor power points

Need a qualified electrician to install 6 downlights in the living room using the existing points that are controlled by 2 switches. Another 2 in the master bedroom, and 2 each in 2 bathrooms.

Hello, We are looking for a licensed NSW Electrician to attend our retail store, in Westfield Parramatta, to replace three faulty track light fittings. The Issue: Three of our ceiling-mounted track spotlights have gone out, which is dimming our sales floor. As these are integrated LED units, the entire fitting needs to be replaced, not just a bulb. The Job: The task is to supply and install new, like-for-like replacements for the three faulty lights. The scope of work includes: 1. Safely accessing the light fittings on the high ceiling track (a suitable ladder is required). 2. Removing the three faulty light fittings from the track. 3. Supplying and installing three new, identical replacement track light fittings. 4. Testing the new lights to confirm they are fully operational and set to the correct colour temperature. * Light Specification (see attached photo of label) Please note: The successful contractor MUST be able to source and supply the three specific light fittings. The cost for these items must be included in your final offer. Location & Timing: Location: Westfield Parra 159/175 Church St, PARRAMATTA NSW 2150 When: The job can be completed at your earliest convenience. Please state your availability in your offer. Please provide a comprehensive quote for the complete job. Your offer should include all labour costs AND the cost of supplying the three specified track light fittings. Thank you.

Need one external power point to connect wall fan on the deck Nearby points are garage, backsideof the wall is kitchen switch board boards Brick wall outside

-the AC turns on only on the fan mode, not on the cold mode. The fan outside isn’t spinning when turned on -Deep clean of one air conditioner unit. Last cleaned 12 months ago and not used much in the last couple of months.

Hello, We are looking for a licensed NSW Electrician to attend our retail store, in Stockland Merrylands, to replace a faulty ceiling light. The Issue: One of the recessed LED downlights in our pre-test room has stopped working. The Job: The task is to replace the faulty LED downlight to restore full lighting. The scope of work includes: 1. Safely accessing the light fitting in the ceiling (Ceiling height approximately 4 meters - a suitable ladder is required). 2. Diagnosing the fault (e.g., failed LED unit or a faulty driver). 3. Supplying and installing a new, suitable replacement LED downlight and/or driver. 4. Ensuring the new light's colour temperature and brightness matches the other existing lights in the room. 5. Testing the new light to confirm it is fully operational. Please note: The successful contractor must be able to source and supply the correct replacement light as part of their service. The cost of the new light should be included in your offer. Location & Timing: Location: Stockland Merrylands 1 Pitt Street, Merrylands NSW 2160 When: The job can be completed at your earliest convenience. Please state your availability in your offer. Please provide a comprehensive quote for the complete job. Your offer should include all labour costs AND the cost of supplying one new LED downlight fitting. Thank you.

I require a licensed electrician (with current NSW registration if applicable) to carry out the following work: Connect four ceiling fans (each with integrated lighting) to the existing lighting circuits/final subcircuits. The fans are already assembled and securely mounted to the ceiling joists using appropriate fan-rated brackets/supports. The previous light fittings have been removed, leaving the existing ceiling roses or junction boxes ready for connection. Each fan includes a light kit, and the supplied remote control receiver/handset allows independent operation of the fan motor and the lights (i.e. separate switching/control via remote). Supply and install two double GPOs (general purpose outlets / power points) in the attic/roof space. This will involve running appropriate TPS cable from the nearest existing circuit or distribution point in the roof space (or as determined on site), installing two flush-mounted or surface-mounted double socket outlets in suitable locations, complete with architrave brackets or wall boxes, attaching to a single timber frame/joist as required, and making safe connections back to the existing cabling. The attic has a catwalk/platform with carpet underlay, allowing comfortable and safe access without risk of falling through the ceiling. Please see the attached photos showing the existing ceiling wiring/rose and the fan's wiring diagram/label for reference.

I am looking for electrician to change the light in the kitchen , need to upgrade,the new light is Luce Bella 30cm Alabaster Oyster Light - Due date: Flexible

I’m after a quote for two jobs at my home: 1. relocating an existing light switch to a different position on the wall, and 2. fixing a bathroom lighting issue where one bathroom’s lights only work when the other bathroom’s lights are on. Could you please let me know an estimated cost (or range), whether it’s fixed price or hourly, and any call-out fee?

Hi I need someone to install an outdoor power supply socket in the wall twin switch. I have one inside the building, and need outside point just at the back of it. So no need for any wiring etc. I have attached photos, could explain. Its a sparky job, would prefer you are certified and you supply that outdoor plug twin switch. So please provide your quotes with labour and material separation. Thanks ( if price is good then there is another similar point on the other end of balcony. I would include that too)

I have a power socket with a stuck charger in it, need to replace it preferably one with a usb ports with the power outlets.

Seeking a Level 2 ASP for a consumer mains upgrade at a residential property in Lidcombe. The current 6mm consumer mains are insufficient for a new 42kW battery storage system and 6kW PV array. I require an upgrade to 16mm² XLPE mains to meet AS/NZS 3000 standards and ensure adequate current carrying capacity for high load off peak charging. The site is currently equipped with an EDMI Atlas Mk7A smart meter (NMI available upon request). The scope of work includes the mains upgrade and a full switchboard compliance check to prepare for a transition to a Time of Use EV energy plan. Please include your NSW Electrical License, ASP Category 1/4 credentials, and confirm that a CCEW will be issued upon completion. Point of attachment is easily accessible.