Find trusted local electricians in South West Perth

Install two split systems at Calista. Units (supplied by me) Two Midea Venus 2.6kW reverse cycle split systems (model MFAG26VB), purchased from Costco. Unit 1: Master bedroom Head unit: high on the northern wall, at the left hand end near the corner. Condenser: outside on the western wall of the side nook on the northern side of the house, under the eaves, wall bracket mounted at an elevated height 1.5m off the ground. This should be a short pipe run straight through the wall. Please keep the condenser within the nook so it doesn't project into the side driveway. Unit 2: Living room Head unit: on the southern wall, above the window. Condenser: outside on the southern wall, approximately 1.5m off the ground and below the window so it's out of sight. Pipe run approximately 1.3m.

Install a power point in the garage

6kw heater, outside power point available Require upgrade and 32 amps power

Need the following electrical work done on my Prado 150 / 2014 model - install usb c charging x 2 - hardwire front dashcam (dashcam provided) - 2nd battery to be able to jump start main battery (batteries already have been setup see images) - solar input output display on dash - run new reverse camera has factory one already installed -12v wiring to fridge in boot disconnects and connects again Engine bay photos are of the Prado Also needing some auto electrical work done on my partners Colorado error codes in image attached Located in singleton 6175

Need and smoke alarm and RCD test as part of the sale of a property in Leeming

Install air conditioner in bedroom

Hi, need a licensed electrician in Baldivis 6171 to repair fixed wiring that was cut during drilling to install mounted TV Also need 4 LED outdoor wall light / wall sconce installed, wires already there , currently there are cheap light globes instaled, need to replace with new ones refer to pics

hi just looking for someone install back gateways for my solar system batteries to run my house if a power outage happens so I dont loose power. I have a goodwe system and a new type meter box pm offers please

RCD keeps tripping have pulled out all plugs

My gutter installer was prevented from replacing a small section of gutters on my home as the solar panel bracket was preventing him from lifting the roof tiles in order to access the gutter. Need to coordinate the lifting of 3 panels with the installation of the gutter.

We are looking for a qualified and experienced Electrical Test & Tag Technician to carry out electrical safety testing and tagging of equipment at our photography studio in O’Connor. The work involves inspecting, testing and tagging electrical appliances and equipment to ensure they meet applicable Australian electrical safety standards.

Hi, I’m looking for a licensed electrician to relocate or install a power point lower down behind my refrigerator. The existing power point is approximately 1.93m above floor level, while my fridge cable only reaches 1.82m. I’m looking for the most cost effective, safe and compliant solution, ideally using the existing electrical circuit. I’m also open to a neat surface-mounted option if that reduces the cost. The job is relatively small, and I can provide photos of the existing setup. Please quote including materials, labour and any call-out fees. Thanks!

Electrician required to install 5 power-points

EC REQUIRED supply and change 3 x plugs/ switches to Clipsal Iconic Vivid/extra white range. need 1 x 1 gang power point 1 x 1 gang switch 1 x 2 gang switch

Supply and install 4 x downlights that have blown

I need 1x new ceiling fan (DC) installed (raked ceiling), also need 2 LED downlights repositioned in ceiling and cabling run into proposed WIR for future LED lighting.

Job is to hang two mirrors on a plasterboard over brick wall. One of the mirrors is to be hung above a power outlet, so you will need to identify where to put the anchors. Need to supply the hardware for hanging (masonry plugs, screws and hooks) in addition we have a set of three small square floating shelves, and a floating shelf with a coat rack that needs to be hung in a kids room and a set of two long, narrow floating shelves

Brick house 3 power points used for general use (lamps, charging phones etc) All points already have another power point on the same wall. One in kitchen One in bedroom One in lounge area

Electrician Required – Bull Creek (24th or 25th June) Looking for an electrician to complete pre-wire and final installation for approximately 20 downlights in a residential renovation in Bull Creek. DOWNLIGHTS ARE PROVIDED. Install plug bases/sockets for downlights before the new ceiling framing and gyprock are installed. Supply and install any required switches, cabling and accessories. Property details: Existing ceiling is being replaced with a new gyprock raked ceiling. Preference for work to be completed on 24th or 25th June. Quote per Downlight please.

Fix the light. I’ve changed light globes and tried different ones but it only is very dim and sometimes flickers. Not sure if there is a loose wire or connection problem.