Find trusted local electricians in Pascoe Vale South

1. We need to update an external fuse box in the garage worshop, 2. Replace 2 new power points. 3. An external wire from above the garage workshop to the roof line. Advise type of fuse box and the materials that will be used, Timeframe for completion of job and total cost of job inclusive of GST.

Bosch Washing Machine (Circa 2014 purchase) is cutting out during spin cycle stage and triggering the circuit board safety cut-out. It is plugged into a wall socket by itself in the small laundry cupboard we have. Unable to release the drain pump impeller on the bottom right of the machine, although pump still appears to drain the machine correctly. Need help diagnosing and repairing! No previous issues to note with it.

Power out to part of the house. Switch on switchboard being tripped by something. Need licensed electrician to inspect and advise on further work required to fix. - Due date: Needs to be done on Monday, 8 January 2024

Install two power points to room - Due date: Flexible

Car electrical system is not working properly. Needs a repair - Due date: Flexible

Install new sensor light and install new heat light in bathroom Install new Downlights I have provided the following just need installing

Two cables need repair due to dog damage. Cable One is an NBN cable that runs off the street, up through ground into property and to PCD box. There is a tear just before it connects to the PCD box. So the tear is in the cable from street to PCD not PCD into building. Cable Two is the phone line that also runs up from the street at the same point and into the conduit and then into the property. It also has been chewed by the dog. Please see photos. Any questions, please ask. Date flexible. NBN contacted but no response for two weeks. These cables run from the street and up into the property at this point. Cables coming out of the ground are still visible. - Due date: Flexible

Hello, I have a task to replace the holder/sockets for 2 of the downlights above our stairwell. It appears the sockets have become old and rusty and would need someone to replace the sockets for the 2 downlights. Regards, Vinayak

Run a cct from switchboard (upgraded) to kitchen for the electric cooktop (not induction). 32A cooktop. Around 10-15m from switchboard. Normal pitched roof, brick house on stumps. AND Install a wall PowerPoint for the rangehood. Time is very flexible.

My electric beauty bed won’t go up or down. I’m guessing it’s the wiring.

Looking for a professional electrician to install 4 pendant lights in a ground floor apartment. For one of the pendant, can replace one of the existing down lights. The other 3 needs to be installed over the kitchen island.

I need to install 7 double power points and 8 downlights. And the electrician needs to supply the materials

We have lost the key and remote for our electric gate and need a locksmith to open so we can override to manual mode.

Need a 9m trench dug in my backyard for electrical conduit. 600mm depth and 100mm width. Date is weather dependent, but between Sept 18-20. I want someone with one of these mechanical trenchers to do the job. https://www.redroo.com/commercial_environmental_equipment/trenchers/display/31-ht912-hydraulic-trencher

To remove an old rangehood and install a new one as per the attached photos.

We have a little balcony that could do with 2x double GPOs added to it. One near the roof and one down low. So we can connect some lights and power items while using the balcony.

Looking for someone to install a skylight window in kitchen.

Please install a new power point as per pictures. Please provide materials. Pascoe Vale South. Thanks

we need 8 panels at 1kw each panel and 2 panels per hot water system. if you cant supply single 1kw panels then it cant work unfortunately. We have 4x hot water systems. we need 2KW solar panels supplied and installed per apartment on the roof. the hot water systems are there now but not much room for panels, hence the 1kw per panel rule as we need 2kw per system. scaffolding is already there to make life easier for the team of installers.

Need a licensed electrician to replace 4 LED downlights in my apartment. Prefer someone with a ladder as I don’t have one to reach the ceiling. Not sure about the specification and dimension of the existing ones. If you need any inputs regarding that I can provide. It’s hardly 5 mins task.