Find trusted local electricians in Mount Waverley

I need a second power cable run from my solar panels to the inverter.

My recliner is stuck and electric has failed

I’m looking for a licensed electrician to carry out electrical work at my commercial bakery in Mount Waverley. Scope of work 1. Install a new dedicated 32A three-phase outlet for a commercial Hobart oven * Approximately 10 metres from the main switchboard. * Supply and install a 32A 5-pin three-phase outlet. * Install a new dedicated circuit breaker and all required cabling. * This circuit is for a Hobart commercial oven (415V, 3-phase). 2. Install a new 15A single-phase outlet in the rear work area * Approximately 15 metres from the main switchboard. * Supply and install one 15A single-phase outlet for future bakery equipment. * Install all required cabling, protection devices and circuit breaker. * Please ensure the installation complies with Australian Standards. Requirements * Must be a licensed electrician. * Quote must include all materials, labour, fittings, sockets, breakers and installation. I want a complete, ready-to-use installation. * Please advise if any additional work is required after inspecting the site. * Provide a Certificate of Electrical Safety (if required).

I need to put in 12 downlights and have our pendants replaced in the kitchen We live in a 2 storey house See photos

Need an electrician to put a 32amp wiring for an induction cooktop.

Need removal of island benchtop Need to have plumbing capped and GPO set aside for new benchtop Solar panels need to be removed from the roof. Already disconnected from isolators No need to dispose

Replace existing light switch making a buzzing sound in the light fixture

Need to repair/replace three Classic 2 Gang Switch and one PowerPoint Double GPO switch

We have 16 to 20 downlights upstairs and downstairs. The ceilings are high 4 m and so a tall enough ladder is required to get there. It’s just changing it from bright white to one white setting which is a flick switch on the inside of the down light we’ve been able to change all the ones with the low ceilings with no problem

Timberflame Radius (IB35ETR and IB35R) Gas Heater - would like a gas safety check and need electrical wiring connected which I think is somewhere underneath house.

My Hager 16A RCBO (Power 7) trips immediately and cannot be reset. I've already completed the following checks: • Unplugged all appliances connected to the affected circuit. • Turned the hardwired fireplace fan wall switch OFF. • Switched the RCBO fully OFF and then back ON to reset it.

Need long ladder to install one of the cameras

Hi there is a crack in the current light . I’ve ordered a new glass piece and it will be available by next Monday . I need an electrician to take it down , replace the light and fit it back in . How much approx is it for a light fitting ? Here is a photo of it ?

Socket burnt out to be replaced with similar double plug outlet

My son accidentally broke the glass in the light in the bathroom. We are moving out next week and I need to replace it or replace the glass asap . Can anyone fix this ?? Or know where to buy a new one exactly the same one ?

Diagnose and repair two outdoor floodlights. The conduit leading to them maybe waterlogged. The conduit itself is about 8 foot above the ground on top of a pergola.

I need to service my 18 solar panels

Remove and replace 6 downlights, I can purchase the necessary lights from Bunnings based on your advice

8 downlights to be changed..brighter lights required..

Existing Clipsal switches and power plugs Replaced with new Clipsal Iconic Switches. No new connections required. There are around 35 power plugs, and around 20 switches to simply be replaced. The 4 switches includes existing dimmer and fan - these are existing and simply to be replaced with new Clipsal. All items have been purchased and ready to be replaced.