Find trusted local electricians in Belconnen

Electrician needed to isolate, disconnect and cap power supply to an old heater which was removed by gas fitter.

New plastered wall. Previous power outlet has been plastered over/disconnected, but existing wiring is still in the wall. Looking to wall-mount a TV and install/reconnect a power outlet concealed behind the TV so there are no visible power cables/outlets. Licensed electrician required, ideally someone who can do both the electrical work and TV mounting.

Electrolux cooktop switches on and off. When I switch the cooktop on,there is a sparky noise before the entire panel switches on and off. This started yesterday. Need this fixed ASAP and require a licensed electrician.

Looking for a licensed electrician to diagnose and repair an electrical fault in a detached room/outhouse. Several power points along one wall have suddenly stopped working, including the outlets used for the fridge and microwave. Other power points in the room are still working and the lights are working normally. The circuit breaker is still on and I have switched it fully off and back on, but this hasn't restored power. There appears to be a clear point where one power point works and the remaining power points along the wall don't. Looking for someone to fault-find the circuit and repair whatever is causing the issue. Happy to discuss additional cost if further materials are required.

Have a working but faulty ceiling fan that needs to be replaced with a spare fan new in box that I have. Fan is currently connected to power but just needs to be replaced.

Kitchen hub switch possibly needs replacement and review of flickering ceiling light.

I have a 3-button glass touch light switch/panel controlling the lights in my bathroom. The 3 switches stopped working at the same time, but the blue indicator lights on the touch panel are still illuminated. The other bathroom switches/power are working normally. Looking for a licensed electrician to diagnose and repair the issue. Please quote for call-out/diagnosis and advise cost before replacing any parts.

We have an LG wall-mounted Air Conditioner that is not responding to the remote. I have twice, replaced the remote unit and while on occasion, I can turn on the Air Conditioner, I cannot turn it off and have to do so at the switchboard. I therefore believe that the Infrared receiver board may be faulty and should be replaced

I got a new Zappi EV charger coming on Saturday 11:00 am. I am looking to install at home, for my byd seal. I have a solar connected ‘GOODWE’.. wondering if someone can do it..

## Licensed & Insured Electrician – Bathroom Renovation Looking for a **licensed and insured electrician** to complete electrical works for a bathroom renovation. **Scope of Work:** we are looking for a quote for the below: * Electrical **rough-in and fit-off** * Install **power points** * Install **light switches** * Install **Atom Moriz Tastic lights** – supplied by the client * Complete all required electrical testing and certification * Must have own tools and equipment **Requirements:** * Current electrical licence * Public liability insurance * Reliable and experienced in bathroom renovation work

I would like to replace 5 flush mount/ recessed downlight with 5new pendant light. I have previously removed a similar light in the study room (4) and discovered that the ceiling hole is larger than the mounting base of the new pendant. I am not sure whether the other 3 holes beneath the flushed mount lights will be too big. I need a professional who can: Remove the current recessed downlight safely. Install the new pendant light. May need to Manage the larger-than-standard hole in the ceiling A swag hook is needed for the lamp above the dining room

Have a fault on a photo light circuit Needs to be inspected and possibly rewired

We need someone to install a 250V AC, 32A single-phase power point, and a sensor light in our garage. Pic of main switchboard, and garage switchboard attached.

Large pendant light to be installed in 2 story high void space. Basic light fitting extant but will need to be electrically wired in.

Looking for a licensed electrician to install a new weatherproof outdoor power point on an external brick wall. There is an existing indoor power point directly behind the proposed location, so hoping it should be a relatively straightforward installation through the wall (brick veneer). Photos attached showing: • Proposed location of the new outdoor power point (marked with red X). • Existing switchboard/meter box. Please provide a quote including supply and installation of the outdoor power point. Located in Florey, ACT. Flexible with timing.

Ev charger removal wall mounted Disconnect from the electric mains.

This was was built by previous owners prior to selling so it could be sold as an extra bedroom - it’s not load bearing and doesn’t have electrical in it. We want the wall removed to the door next to the kitchen. (You can see where the wall has been attached)

I have three recessed downlights installed (wired), only two working at the moment. Would like to replace them with smart lights (likely the Nanoleaf) and also install a Shelly 1 Gen 4 relay switch. The switch controls all three lights. I haven't got Home Assistant set up yet, so assume will need to have the Nanoleaf act as 'dumb' lights, but priority 1 is painting the room! Happy to discuss/get suggestions - the lights and the switch are arriving Monday, but can always return if needed.

I’m seeking a quote for some residential electrical and data-cabling work at my single-storey townhouse in Page, Belconnen. The required work is: 1. Two Cat6 Ethernet runs from the PoE switch location in my living room • One Cat6 run to a wall-mounted PoE tablet in the living room. • One Cat6 run to a wall-mounted PoE tablet in the main bedroom. At the switch location (in the living room only), I would like the termination with Cat6 sockets and maybe one to two spare positions. 2. Tablet installation I already have the two PoE tablets, recessed metal backboxes and mounting plates. Please quote for: • Installing the two supplied recessed backboxes. • Bringing and terminating the Cat6 cable inside each box. 3. Power point • Install one new double power point on the living-room wall.

Hello, We are looking for a licensed ACT Electrician to attend our retail store, in Westfield Belconnen, to replace two faulty track light fittings. The Issue: Two of our ceiling-mounted track spotlights have stopped working. As these are integrated LED units, the entire fitting needs to be replaced, not just a bulb. The Job: The task is to supply and install new, like-for-like replacements for the two faulty lights. The scope of work includes: 1. Safely accessing the light fittings on the high ceiling track (a suitable ladder is required). 2. Removing the two faulty light fittings. 3. Supplying and installing two new, compatible track light fittings that match the existing ones in style, colour, and light temperature. 4. Testing the new lights to confirm they are fully operational. Requirements: - MUST be a fully licensed and insured ACT Electrician. - You must have your own tools, including an A-frame ladder appropriate for a high commercial ceiling. - The contractor must be able to source and supply the two replacement track light fittings. Location & Timing: Location: Westfield Belconnen, Benjamin Way, Belconnen ACT 2617 When: The job can be completed at your earliest convenience. Please state your availability in your offer. Please provide a comprehensive quote for the complete job. Your offer should include all labour costs AND the cost of supplying two new track light fittings. Thank you.