Find trusted local electricians in South West Perth

Hi all 1. Looking for someone to exchange two outdoor GPO in swimming pool shed . It has an existing GPO which is working but loose switch . Has RCD which needs testing too. GPO provided. 2. Changing an exciting LED Flood light 1500W LED will be provided. 3. Need electrical safety certificates on completion of both jobs.

Hi, I need a licensed electrician working under an electrical contractor licence to install two ARIA Gx53 CTC DC ceiling fans with lights in two bedrooms. These will replace the existing ceiling light fixtures. Details: • 2.4m ceilings • Existing wiring in place • Fans only came with remotes (no wall switch included) • We were hoping to have a wall light switch, so any advice on whether that’s possible with this model would be appreciated What’s needed: • Remove old ceiling lights • Install both fans and receivers • Make sure everything is wired safely and working properly • Let us know if adding a wall switch is an option • Provide a compliance certificate

I have three phases power outside and I need to put in a 15 amp PowerPoint for a spa and a 32 amp hardwired power supply for a sauna

I need a electrician for a simple job - replacing the 6-7 existing ceiling light to other ceiling light - need it done by next week

Instal 2 ceiling light fittings (existing wiring in place), 2 wall fittings (wiring also available), replace a light switch and make safe wiring for an outside light fitting.

I need someone to install Christmas light outside and on roof line

Need 2 hard wired smoke alarms also certificate for RCD for house sale

Looking for a licenced electrician to replace the faceplate on a power point under the kitchen sink. I will supply the faceplate.

Hoping to change my normal light switches to smart switches (we will supply). There are 17 face plates and 35 switches plus 8 GPO. Mercator ikuu switches

I have two PowerPoints right next to each other. I need one only - moved about 30cm

Remove pendant and put down light

We are needing 2 double outdoor power points, and one double power point in the garage. House is a low storey brick house.

Needing 4 standard light fittings swapped out with new fittings I bought including 2 x up and down lights and 2 x small twin spotlights. These will go at the front of the house. 1 standard light fittings swapped out with a downlight to the ceiling at the entrance of house. (I have the downlight) I also require a new dimmer switch installed to my hallway as the lights are flickering bad or don’t come on at all.

I have the LEDs and base plugs. I just need an electrician to replace the 4 old LEDs with the new ones. Each new LED gets connected to a base plug.

Replace existing GPOs and Switches throughout the house. Circa 30 of them in total. i want to install the Vynco urban range from Beacon. Install will include a Fascia ontop to give a glassy finish. thanks

1 - remove and relocate marked power point to new location as marked to power new power point near vanity, a second power point in one shaver cabinet, a power source for the two shaver cabinet in the bathroom and a third for the ensuite shaver cabinet that backs onto the bathroom. 2 - replace the light switch in the main bath

I’m needing housing electrical to be disconnect by a licensed electrician 2x Lights and corresponding light switches disconnected 1x PowerPoint

Need new NBN wall socket's replaced in my house.

After quotes for a Licensed electrician to install 1x ceiling fan in Spearwood. Available on Thursday's only. Thanks

I need a pair of brake lights installed on utility tray , I've attached a photo