Find trusted local electricians in South West Perth

Existing ceilings lights to be replaced with new pendant lights and add downlights to four bedrooms and living/dining area, replace a smoke alarm, add new GPOs in bedrooms/living and study

We are looking for a qualified, licensed electrician to carry out some electrical work around a swimming pool pump at a residential property in Coolbellup. An electrical safety inspection has identified some issues with the existing pool wiring that need to be rectified. Work required: Replace the existing wiring running from the house to the pool pump, as it has not been installed correctly. Run new wiring to the pool equipment, including some underground cabling (approximately 5 metres of trenching). Remove an existing outdoor power point in the garden bed that is positioned too close to the ground. Install a new weatherproof double power point near the pool pump. Remove or make safe some old, unused wiring around the pool equipment. Test the completed work and provide the appropriate Electrical Safety Certificate. We are looking for someone experienced with this type of work who can ensure everything is completed safely and meets WA electrical requirements. Must be a fully licensed and insured electrical contractor. Budget: $1,500 including labour and materials. The property is tenanted, so access will need to be arranged. Please let us know your availability and whether you can complete the work within our budget.

-mount starlink to roof (tiles) with cord going into office -replace downlight over kitchen bench (we have it here) -take out dated lights and replace with 2 downlights over kitchen table -install sensor light to outside garage -detach power to sandpit (at house) -check fusebox (just view for your opinion and also on 3 x air con split systems-am concerned about wiring!)

Outdoor power point Light switch moved Power point inside Light pendant installed

I have a pendent light which I need it to be installed above the dinner table. Photo shows where I want light to be handing and number 1,2 & 3 showing closest power point. Number 3 I already has few cables plugged. Single storey and roof/attic access is easy.

Need power points done around the house,and maybe connect down lights

🌟3 LED down lights need replacing in the kitchen 🌟15amp faulty power point needs changing for our spa (it's outdoor but inside the spa cabinet) 🌟3 new pendant lights to be installed (they're just basic ones..not a chandelier or anything - 1 bar light and 2 small pendants) 😊 Based in Baldivis

Looking for a qualified electrician to install approximately 20 downlights. oximately 20 downlights. Downlights will be supplied by us. Please message me with your availability and a quote.

Install isolator switch for air con split system Change one power point Wire up split system air con with a extension cable

Remove old light in kitchen and install new one

Supply and install 4 x downlights that have blown

Need a licensed electrician for my pool equipment area. Work needed: * Install 4 x outdoor/weatherproof power points * Wire up pool heater/heat pump * Run new supply from the main switchboard to pool equipment area * Preferred route is through roof space / under eaves if possible (something like the yellow line in the photo) * Happy to consider a small weatherproof sub-board near the pool gear if that makes more sense Photos attached showing switchboard, equipment area and likely cable route. There’s also an existing double power point on the other side of the pool, with conduit and a cable already running toward the pool equipment area, but it’s currently disconnected. Might be worth checking if any of that can be reused.

Had western power do a home inspection and they found the below that needs looking at. Will also need the western power page signed so I can show them the work is completed. “ The Active and Neutral conductors at the load side of the pool RCBO were transposed. The homeowner is to engage an Electrical Contractor to complete testing to ensure correct polarity at all power points and equipment associated with this circuit. “

I need 1x new ceiling fan (DC) installed (raked ceiling), also need 2 LED downlights repositioned in ceiling and cabling run into proposed WIR for future LED lighting.

Job is to hang two mirrors on a plasterboard over brick wall. One of the mirrors is to be hung above a power outlet, so you will need to identify where to put the anchors. Need to supply the hardware for hanging (masonry plugs, screws and hooks) in addition we have a set of three small square floating shelves, and a floating shelf with a coat rack that needs to be hung in a kids room and a set of two long, narrow floating shelves

Brick house 3 power points used for general use (lamps, charging phones etc) All points already have another power point on the same wall. One in kitchen One in bedroom One in lounge area

Electrician Required – Bull Creek (24th or 25th June) Looking for an electrician to complete pre-wire and final installation for approximately 20 downlights in a residential renovation in Bull Creek. DOWNLIGHTS ARE PROVIDED. Install plug bases/sockets for downlights before the new ceiling framing and gyprock are installed. Supply and install any required switches, cabling and accessories. Property details: Existing ceiling is being replaced with a new gyprock raked ceiling. Preference for work to be completed on 24th or 25th June. Quote per Downlight please.

Fix the light. I’ve changed light globes and tried different ones but it only is very dim and sometimes flickers. Not sure if there is a loose wire or connection problem.

Instal/replace 3-in-1 Bathroom Heater, Exhaust Fan and Light in White with 4x 275W Heat Lamps

Switches will be provided. Need them installed.