Find trusted local electricians in Outer East Melbourne

Replace three electric Switches

Error on heat pump error code 512 Hot water temp rarely hot Stiebel Brand

Installation of a 15a circuit to run a 3500w boiler. Boiler has 15a plug and not hard wired. Location is in the garage and socket location is approx 4m from the switchboard on the same wall (brick). Spare slots available in the switchboard

I have 17 panels at 250w system 5kw Inverter Up to 4 panels have been diagnosed as cracked and stopping system from working. Options to repair Removing 4 panels panels. Confirm system works again. Replace 4 panels 250w that can be sourced from Marketplace. I shall supply. Located near Ringwood Single storey Ask questions

Need a light installed, can get the wires from existing fan/light, the existing fan light not bright enough so wanting new LED light supplied and installed

Install 45 330 kW solar panels I have rails and roof brackets also need a full house backup on my ESS box Battery

The hot water comes only for few seconds and then stops. It is a Chromagen solar water heater with the gas booster.

Light fittings installed x 4 wall sconces and to ceiling Outside lights checked, not working x 3 Reconnect socket in kitchen

Need a power point to toilet

Please help me light my pilot light of my gas water heater.

I am looking for a quotation to install 4 downlights and replacing a ceiling fan in our master bedroom. I will provide the downlights and new fan and other wiring if needed.

Hi there, I am currently doing some home renovations and need a licensed electrician to update the connections for 5 existing LED wall lights. Current situation: There are 5 old LED wall lights (70mm cut-out). Their LED drivers are currently hardwired into the mains behind the plasterboard. What I need you to do: • Remove and safely disconnect the 5 old hardwired LED drivers. • Supply and install 5 standard surface sockets (plug bases, e.g., Clipsal 413 or similar) at these existing points. • Push the new sockets back into the wall/ceiling cavity safely. Important details: • No new wiring or cutting new holes is required. The 70mm holes and the wiring are already there. • I will supply and plug in the new downlights myself once the sockets are ready. You only need to supply and install the 5 surface sockets. • You must be a fully Licensed Electrician and be able to provide a Certificate of Electrical Safety (COES) upon completion. Please let me know your availability and your quote for the complete job (including the supply of the 5 sockets). Flexible with dates but prefer to get it done soon. Thanks!

I need to replace a light switch. I tried doing this myself but it hasn’t worked. ChatGPT says it is a 5 minute job

Need to replace the 8 down lights Dimmable lights - 6 Normal - 2

Need to have power connected for a Spa - 32 amp direct to switch board Power connection for a Water tank pump

Install three ceiling fans DC with remote controls (fans likely don’t need roof access as fans already exist in the same spot) and additional electrical wiring added at three different points in the house for the install of Arlo cameras

Lighting Works (Quantities Included) Downlights 21 × NEW LED downlights (new cut-outs & wiring) 14 × LED downlights to replace existing halogen fittings Total LED downlights after works: 35 Oversized retrofit trims required where replacing halogen cut-outs Other Lighting 4 × LED linear / channel lights (replace existing in pool room) 2 × Bedside wall lights (master bedroom) Light Removals 2 × Pendant lights (study & dining) 1 × Wall light (entrance) 1 × Fluorescent tube light (kitchen) Switching 9 × LED-compatible trailing-edge dimmer switches Includes isolation, disconnection, and removal of existing switches Reuse existing switches only where specified Additional Electrical Works 1 × New double power point in garage 1 × Main switchboard upgrade (RCD/RCBOs as required) Technical Requirements LED downlights: 3000K warm white CRI ≥ 90 IC-4 rated Visually consistent trim style throughout Ceiling make-good: patch only, no painting All removed fittings to be disposed of Works to comply with AS/NZS 3000 Electrical Certificate of Compliance required

I need Electrician to change some lights and switches in two bathrooms First Bathroom - one room has become two rooms, additional switch and light, fan heat light in the new room, Second bathroom, two rules have been combined and one switch is required, light fittings supplied by me, Replacement of free in one heater light and fan, relocation of another fan,

10 downlights for three bedrooms and a hallway area upstairs. And remove old lights. Price with and without dimmers in rooms please.

Recently completed plaster ceiling & need to install 3 x LED downlight.