Find trusted local electricians in Wantirna

Looking for an electrician to complete some electrical work on an internal feature wall in my home before a decorative wall mural is installed. Please refer to the attached photos of the wall. Scope of work: 1. Remove existing wall light fitting: Safely disconnect and remove the existing light fitting from the wall. Make the wiring safe and terminate and insulate it in accordance with Australian electrical standards. 2. Install flush blanking plate: Fit a neat, flush, paintable blanking plate over the existing light outlet, junction box or wall opening, as appropriate. The finish needs to be as low-profile and unobtrusive as possible so the wall mural can be installed neatly over or around it. 3. Remove existing power point: Safely disconnect and remove the existing wall power point, including making the wiring safe and appropriately terminating it. Install a suitable absolutely flush blanking plate to cover the opening, leaving a neat finish for the mural installation. 4. Install LED strip lighting: Supply and install approximately 3.5–4 metres of LED strip lighting along the bottom of the feature wall, above the skirting board or at the wall–floor junction, as appropriate. I’m looking for a clean, discreet installation with an even, warm-white glow. 5. LED installation details: Please recommend a suitable LED strip, aluminium mounting channel/diffuser if required, and an appropriate driver/power supply. Ideally, the installation should have concealed wiring and a neat finish, with no visible cables. Please advise on the best location for the led, driver and switching arrangement. Please quote for the complete job for supply and install and advise your earliest availability.

Looking for two smoke alarms with AC power + battery supplied and installed, and the old hardwired ones removed too. They're in the same area (hall between bedrooms) so no need to connect them to each other.

Rewiring one light fixturedthe from turning to plug style.

This needs to be replaced with a new heating light

I need a licensed Electrician to install my Tesla Gen 3 Wall Connector (hardwired, unit already supplied by me). ​Power: Single-phase supply. Requires a dedicated 32A RCBO circuit installed in the switchboard. ​Cable Run: Short run on brick wall right near the switchboard (see photos). ​Must supply all required materials (cable, conduit, 32A RCBO breaker). ​Must provide a Victorian Certificate of Electrical Safety (COES) upon completion. ​Photos of the switchboard and installation location are attached. Flexible with installation date/time.

Please help supply and install ceiling fans in 3 bedrooms at our home in Wantirna.

Hot water heater doesn’t turn on need to diagnose it and repair if necessary

We need around 30 Downlights to be installed in our home. Some need to be replaced out of 30. Please give the quote for installation and cost of each light separately

Gas, Electricity and Smoke Alarm compliance and safety check.

Change GPOs, switches, batten light and install pendant lights and GPO. There are 5 tasks. Please refer to the attached photos with task descriptions. Batten light product: https://www.voltexelectrical.com.au/p-6735-led-indoor-batten-2nd-gen-multi-power-tri-colour-1-10v-dimmable.aspx Recommend and supply black GPOs, sockets and switches for the garage. Recommend and supply dimmmable switch for bedroom pendant lights. Pendant lights (2x) will be provided.

I’m looking for a licensed electrician to complete some work at my single-storey home in Wantirna. The work required is: Install 2 outdoor weatherproof power points in the decking area (pink arrows). There are existing power points on the inside of the wall, so power may be able to be taken from there. Install wiring and connection points for 3 LED ceiling lights in the decking area. I am planning to install 120cm LED light bars. Install 1 floodlight at the front corner of the house (green arrow). The property is located in Wantirna, and I would like to have the work completed as soon as possible. Could you please provide a quote for the following options: Supply and installation included (power points, LED light bars, floodlight, cabling, and all required materials). Installation only, with me supplying the LED light bars and floodlight. Please also let me know your availability and the estimated timeframe to complete the work. Thank you,

Fujitsu split system air conditioner not working (Economy light flashes non-stop, Operation light flashes once, Timer light flashes once). Was heating fine still a week ago. I have 4 indoor units, all of them have the same issue, same light flashing pattern. Assessment and quote required. (Airtasker does not allow me to attach video)

I need to do test and tag on house hold appliances

Inspect the water heater machine (outdoor gas) to find out the reason why it didn’t working. The fee is just the inspect fee.

To install 11kW EV wall charger . Don’t need supply Double story home 3 phase

Help to install a wall ev charger in the garage. The electric panel to garage about 10 meters.

Electrical compliance check in the whole house and install exhaust fans in Bathroom and laundry.

Lighting Works (Quantities Included) Downlights 21 × NEW LED downlights (new cut-outs & wiring) 14 × LED downlights to replace existing halogen fittings Total LED downlights after works: 35 Oversized retrofit trims required where replacing halogen cut-outs Other Lighting 4 × LED linear / channel lights (replace existing in pool room) 2 × Bedside wall lights (master bedroom) Light Removals 2 × Pendant lights (study & dining) 1 × Wall light (entrance) 1 × Fluorescent tube light (kitchen) Switching 9 × LED-compatible trailing-edge dimmer switches Includes isolation, disconnection, and removal of existing switches Reuse existing switches only where specified Additional Electrical Works 1 × New double power point in garage 1 × Main switchboard upgrade (RCD/RCBOs as required) Technical Requirements LED downlights: 3000K warm white CRI ≥ 90 IC-4 rated Visually consistent trim style throughout Ceiling make-good: patch only, no painting All removed fittings to be disposed of Works to comply with AS/NZS 3000 Electrical Certificate of Compliance required

Need an electrician to install a wifi dongle in an inverter

Need more space for further modules