Find trusted local electricians in Ringwood VIC

Qualified electrician looking for subcontract (subby) work. Reliable, punctual, and take pride in clean, high-quality installs. Experience across residential, commercial, and maintenance. Own tools and transport. Happy to work independently or as part of a team.

Hi there, I am currently doing some home renovations and need a licensed electrician to update the connections for 5 existing LED wall lights. Current situation: There are 5 old LED wall lights (70mm cut-out). Their LED drivers are currently hardwired into the mains behind the plasterboard. What I need you to do: • Remove and safely disconnect the 5 old hardwired LED drivers. • Supply and install 5 standard surface sockets (plug bases, e.g., Clipsal 413 or similar) at these existing points. • Push the new sockets back into the wall/ceiling cavity safely. Important details: • No new wiring or cutting new holes is required. The 70mm holes and the wiring are already there. • I will supply and plug in the new downlights myself once the sockets are ready. You only need to supply and install the 5 surface sockets. • You must be a fully Licensed Electrician and be able to provide a Certificate of Electrical Safety (COES) upon completion. Please let me know your availability and your quote for the complete job (including the supply of the 5 sockets). Flexible with dates but prefer to get it done soon. Thanks!

Hi, we need an electrician to attend a coin laundry in Ringwood. ​We had a power outage, and while the mains power has returned and all circuit breakers are in the "UP" position, the automatic overhead lights (controlled by an HLP analogue timer) are not turning on at the right time. Have tried to adjust all the timers pictured but the light is still turning on at wrong time (3am).

Looking for a licensed electrician to upgrade the main electrical supply from 40A to 63A for my townhouse Property details: • Townhouse built in 2022 • Single-phase supply • Tesla Powerwall and solar installed • Current main breaker is 40A • AusNet has confirmed 63A supply is allowed • This is a multi-unit townhouse complex, but each unit has its own meter and supply. Scope of work: • Check consumer mains cable from meter to Tesla Gateway / switchboard • Upgrade main breaker from 40A to 63A if compliant • Make any required switchboard adjustments • Complete any required electrical paperwork

I need switch board replaced in my restaurant one of the switch doesn’t work properly

Change 2 faulty electrical switches. I have bought replacement switches. good to have a certificate as well.

Two points for sonos speakers. Double story house

To get a fan and Florence lights working and also provide a switch

I need a qualified electrician/data technician for the following tasks: 1. TV Power & Cabling • The TV is already wall-mounted, but the existing power points located below the TV need to be removed. • There is a power outlet behind the TV that currently sits in an oversized hole. I have a recessed outlet that needs to be installed there. 2. Additional Power Outlet • Install one new power outlet inside the small under-stair storage area. 3. Data Cabling • Run two Ethernet cables, both terminating in the server cabinet: • One cable from the front door to the server (for a doorbell). • One cable from the garage to the server (for a security camera). 4. Faceplate Installation • Install three recessed faceplates (already provided). These require extra depth, so space behind them may need to be adjusted. 5. Pendant Light • Lower the existing pendant light to the desired height.

Install a new smoke detector in the hall way

Need a new power point installed in the bathroom prior

I need an electrician to flip over a ct clamp. Takes less tac a minute

What we need is receipt with ABN on it. Its a couple of hours job.

2 tasks please in Ringwood townhouse: 1. Replace 1x 240v wired smoke alarm. already purchased Quell q2300 smoke alarm from First two photos 2. I removed an old hard-wired smoke alarm and temporarily taped the wires and pushed them above the ceiling for safety. Need help to -Drill a new hole in the ceiling (will point out the exact location,show in 3rd photo) - Remove the tape from the wires - Terminate the wiring properly using a connector or similar safe method. Standard high ceiling.flexible timing.

Full house rewiring, 3bed 1970s house. Remove old wiring & switches. New wiring via roof cavity or underfloor. ~20 lights, 25x mains connection, electric cooktop, double oven, external connection for heat pump, electric water heater heatpump, spare, gate. New switches and mains socket. Upgrade to 3 phase connection. Ready for solar, battery and EV charger. New main panel at new location on different sidewall

One of my front lights It will trip and The lights on this line are all off. when I press this switch, (sometime) There is also the smoke alarm.need change battery.

Hello, We are from Oscar Wylee. We need to replace store downlight. Please send your quotes for Supply and replace the downlight.

Remove solar panel and rails on roof . The electric wire is disconnected

Changing all the ceiling lights if a double storey 4 bedroom home with downlights. The existing lights are mainly flush ceiling ones. The position of the downlights need to be designed and the existing lights removed. I project we need 50 to 60. downlights to replace the current setup. Only one extra switch is required to separate a light's circuit. I need the whole project including design, material and labour to be quoted please.

Needing an electrician for two tasks. - hookup our Westinghouse ceramic cooktop (the wires for the cooktop and killswitch have already been set up during renovations). - install 2 power outlets in a bedroom Ideally wanting to get this done today (Thursday) or tomorrow (Friday)