Find trusted local electricians in Lilydale VIC

Help me replace the light fitting, including parts with the cost.

Need split system install in lilydale. Back to back single unit around 8kwh. Flat roof

Fixed hourly rate. Put a lock on a door, change an outdoor light to a sensor. Install a battery sensor light. Check a power point to see why it's not working.

Reroute electrical and replace all outlets and switches. Wire in new lights and fan. 6 x down light, 1 x ceiling fan, 1 x PowerPoint (same position as existing), 1 x heated mirror ( beside existing powerpoint)

Motorised blinds hard wiring installation

Roller door motor stopped working. Need to diagnose issue. If issue is the motor to be replaced this is not included in this price. 7m high roller door.

Our solar panels aren’t feeding power back to the grid. Was notified by provider and checked inverter screen which is appearing blank. Tried on/off with no success. Task to fault find and repair where possible.

Have a reverse split system that needs installation, (7.1kw) Already supplied

I’m looking for a licensed electrician to install a manual changeover (transfer) switch for a portable generator (3.5–4.5 kW, single-phase 240 V) to supply limited power during outages. Install preferred before Jan 8th if possible. Scope: • Supply & install 2-pole manual changeover switch (GRID / OFF / GENERATOR) • Install weatherproof external generator inlet socket near switchboard • Connect selected essential circuits only: • Lights • Selected GPO circuit (incl. fridge) • Exclude high-load circuits (A/C, oven, hot water) • Generator located < 3 m from switchboard • External surface conduit acceptable • Ensure AS/NZS 3000 compliance • Prevent any grid back-feeding • Test, label, and demonstrate operation Notes: • Existing residential switchboard with RCBOs • Generator supplied by owner • Manual changeover only (no automatic switching) Happy for essential circuits to remain individually controlled via existing RCBOs, with manual isolation of non-essential circuits during generator operation. Please quote parts + labour and confirm electrical licence.

Power points: Move 3 power points over approx. 30-50cm from their original locations (pictured with red arrows) Lighting: Add in 3 pendant lights (middle of living room, middle of master bedroom, and above dining table). There are currently downlights in these areas. These can stay or be swapped / disconnected for the pendant lights (whatever is easiest). (one of these pendant lights has wiring, the other 2 are just shades and globes with cords that connect to a standard power outlet. If you are able to wire these in, we can do that or we can buy whichever cords you recommend). 2. Replace the pendant lights above the kitchen island with 1 linear pendant

Electrician required to fit off kitchen renovation PowerPoints are already in position so will only need them to be reconnected in the new cabinetry. > Under sink > Behind oven (PowerPoint already exists for gas stove so assuming that will just be upgraded) > Behind Microwave Cabinetry is being installed around the 15th.

Small wiring issue with Harley fuel pump wiring after attempting to change battery. Somewhere along the line I've either lost a wire or back of fuse wire has come out to fuel pump fuse on block. Need someone who knows bikes and able to help me as soon as possible today

Need a boiler to be connected to electric

needing a plasterer to patch holes from electrical work done and stop out Happy for a per hr price

**CERTIFIED ELECTRICIANS ONLY - Add 2x wall art lights (already have them) - Replace 3 light fixtures with pendant lights above the kitchen island(already have them)

Ac installation, ground floor. New installation 2 units to install in same plave

Needing an electrian to disconnect: - Solar panels/battery - Backup diesel generator - electrical connection between two halves of cabin

Looking for a skilled professional to: 1. Install LED strip lights between wall panels on a large wall. 2. Supply the LED strips (as they are not available). 3. Relocate the current light switches (or plugs – unsure of the correct term) from outside the wall panels to inside the panels for a cleaner look. The wall is large, so experience with similar projects and attention to detail is a must. Feel free to ask for more details if needed. Thanks!

repair of ITM / PILOT generator

Ceiling down lights are flimsy. Some takes time to turn one, some dar brighter than others and 1 wont turn on at all. Same with another normal ceiling light in the kitchen. Maybe wiring needs to be looked at. The bulbs are working fine.