Find trusted local electricians in Newport VIC

Two downlights on upstairs ceiling requiring to be replaced. One additional downlight in family room needs replacing and one in the hall way. A tall ladder is required for stair ceiling down lights.

Job Title: Lift Heat Pump Dryer Onto High Shelf (2-Person Job) Details: I need a heat pump dryer (~50–60kg) lifted into place onto an existing high shelf with brackets.     •    No installation, plumbing, or electrical work required.     •    Just a careful 2-person lift into position.     •    Space is tight, so needs a bit of manoeuvring Notes: Please bring a second person to help with the lift. Not possible with one person

I have 14 old style down lights that I would like changed out to LED lights throughout my apartment. Apartment is first floor. Will need supply and install.

Install new air conditioner unit back to back ground level unit through brick wall. Power already installed.

Replace light fittings in ceiling of two rooms. Suggestions for best replacement fittings would be helpful.

The fuse box is approx. 30cm wide, but then has electrical coverings that run out from it. Looks terrible, and am finally getting around to covering it with a simple box-style feature than I can paint.

Looking for an electrician to fix a ceiling fan/light remote and replace one down light - open to offers

Location Newport. Remove existing gas unit and install new heat pump system. Please provide details of the unit you will be supplying.

LG Art Cool aircon unit turns on and after about 2 mins turns off on its own

I have an investment property in Newport that requires some electrical work. It was built in 1935 however has a small extension possibly in the 70's 1. In the extension there is a switch to a light fitting that did not work. the batten was removed and wires isolated. there is a single red and then a cable with a black and red, Earth wire may be in the ceiling cavity. Just need a batten wired and can assist in retrieving the earth as the ceiling is plasterover tinber. 2. The bathroom does not have an exhaust fan. The light has been removed but would like to install a fan and light (on the same switch) but also require external venting. It is tiled roof so easiest is straight up as the bathroom does not have an external wall due to the extension. Photos can be provided. Electrician to provide fan and light, I have battens.

Looking for an electrician to change to USB-A PowerPoints two USB-C and use the leftover USB-A PowerPoints to replace two standard PowerPoints. (photos 1-3) Also to install an additional PP not far from the original. PP supplied. (photo 4)

Safety electrical box installed

Electrician needed to replace exsiting lighting. No new connection required.All materials will be given,just need to bring your tools. Replace 1 x fitting in entry with 400mm LED oyster light. Replace 1 x fitting in hallway with 300mm oyster light. Repace 1 x fitting in bathroom with 350mm black oyster. Replce 2 x pendants with 2 x pin downlights in bedroom. Replace 5 x existing downlights with Comfort LED low glare fittings. Replace 1 x fitting with 1 x flush mounted 3 Light drum pendant.

Ventilation required for a bathroom (first floor), a laundry with a shower in it (grounld floor), and the kitchen. There is a flu in the kitchen over the stove, but it is blocked. Older style timber house.

I believe I need to install a data point in the living room as I want to move my current modem from the bedroom to the living room. The Wi-Fi is weak in the living room, and I would just like to install a port in the living room so it's in the center of the house. Might also install an extra power point so would like a quote for that too. Thanks

I need my electronic door bell fixed. The connection part from the wire has broken, and needs a new connection put on it (see attached photos)

Got 2 power points to check as the connection is loose

Require the replacement of 2x fluted toggle indoor light switches as the current rocker switches are broken. I already have the brand-new parts (do not include these in quote), so just need the electrical labour to detach the old and rewire the new. Thanks!

Hi i am looking for electrician who can help to change my coffee machine to phase 3 from switchboard. I need to put some downlights as well in my shop. Task has to complete tomorrow. Thanks

I'm looking for an electrician to replace 2 existing light fittings with some new ones I've bought. You'll need to be fully qualified and licensed, have a good AirTasker reviews, have insurance with complete coverage, be fully vaccinated, and be able to complete the job by the end of this week. Please provide me with your most competitive quote and your availability.