Find trusted local electricians in Footscray

Replace smoke alarm battery

Hi there, there is one switch that doesn’t turn on completely and lights flicker because of it, need this to be fixed. That’s about it. Need it done before Saturday 22nd November in Maribyrnong. I’m not sure of the costs, so I’ll put what I think and you’re welcome to offer what works for you.

Hi all, Just finishing a minor refresh of a house and need someone to change over my light switches and power points plus do some other works Looking to get this done in about 3 weeks. 1- replace 17 x PowerPoints. I already have all the new power points. 2 - replace 5 x light switches. I already have all the light switches 3 - fit off smoke detectors x 3 and install breaker. Cabling already done and have certificate for it. Need you to supply and install breaker in switchboard and fitoff smoke detectors supplied by me. 4 - fitoff single phase car charger. Cables already done and have certificate for it. The cabling already loops through the isolation switch location. You supply a 32A breaker and a weather resistant isolation switch. I supply the car charger. Thanks Damien

Replace 3-4 light switches that are missing switches or damaged.

There was a spark next to the stove top and now all electricity has gone out. Need someone to come take a look and give a quote

Connect Krone box to new network point. Qualified electrician required. Need to connect NBN service asap

Looking for quote for aircon installation must be certified electrician

Electrical Works Job: Single Phase Mains Upgrade Scope of Works: • Supply & install 16mm² SDI (red & black) • Supply & install single phase fuse box • Supply & install smart hinge meter panel • Supply & install earth electrode with 6mm² earth cable • Complete switchboard upgrade (including surge protector) • Engage electrical inspector & provide prescribed certification of electrical safety

Need a licensed electrician to check the shed wiring in my rental. Outlets and lights aren’t working, looks like a DIY setup from the house. Need it tested and advice on the best way to make it safe and usable so i can pass onto landlord. Possible furtire work if approval is granted.

While unscrewing an old light fitting from the ceiling. The plastic snapped and it fell down. Now I can’t screw in a lightbulb. A new light fitting needs be installed I think.

Electrician to quote to rewire a house. Flooring and some wall sheeting remove for easier access Any day this week would be good

As per the Victorian Residential Tenancies Act, I require a registered, certified, qualified electrician to carry out safety Electrical, Gas, and Smoke detector checks at two properties.

I need a licensed electrician to replace 6 UK plugs with Australian plugs on extension cords. • I’ve already purchased the AU plugs from Bunnings. • Just need the old UK plugs removed and the new AU ones fitted safely.

Remove old light fittings and replace with new fitting in hallway and bedroom

As previously mentioned, 3 ceiling fans and 1 pendent plus 1 power point.

Install fans, pendent light and power point.

Replace five downlights. I have the down lights

This is a real long shot - but looking for an A-Grade electrician to come and run some wiring through my ceiling while my roof is getting replaced. I have a flat roof, and it’s being replaced today - it’s a good opportunity to put a ceiling fan in my bedroom, because I don’t have any ceiling cable - just wall lights. My sparkie is sick! So desperately looking for another!

Hi Airtaskers, I live in an apartment unit and would like to arrange the installation of two internal and one external weatherproof power point. Internal power points: These will be installed on a drywall. There is an existing power point on the opposite side of the wall, which should make wiring more straightforward. External power point: This can either be installed on the balcony drywall (which has a 1-gang switch directly opposite), or on the concrete wall where the outdoor air conditioning unit is located—whichever is more suitable for the installation. The power points I would like to use are the Clipsal Iconic Double Switched Power Point - 10A Horizontal Mount in Vivid White. Product link: https://www.clipsal.com/products/power-points-switches/clipsal-iconic/double-switch-power-point-horizontal-mount-250v-10a-3025?itemno=3025-VW Ideally, I’d like the installation to be completed by 30th April. Please let me know your availability and if you need any further details to provide a quote.

We have a two storey building we are doing a theatre work in and require lighting bars installed on both levels today. We also need a very small room built with the flats we have and a ceiling put on it to attach the bars to. Floorplan attached. Lighting bars are red. Small room space is circled in yellow. We have materials for room but not lighting bars. Photos of the space without the flats we've put up