Find trusted local electricians in Outer East Melbourne

hi, I need a quote for 1) someone to check if 2 existing smoke alarms are working properly 2)check if more smoke alarms are needed, and if so, an estimate to install an additional smoke alarm (including parts) * 3 bedroom house, single storey, tile roof, roof accessible

New bathroom: Install exhaust fan and heat lamp

Wires burned out attached to the ignition switch in a 1938 Plymouth. Coil and ignition switch are working but an electrical fault like a short circuit or loose connection caused the insulation to burn off two or three wires attached to the ignition switch. One wire bring power from the ammeter a second connects to the fuel gauge and the third connected to a starter button on the dash.

Install 2 AC One 7K and one 8k Single flat roof Main unit will be installed on roof and the unit would be inside Easy access for drain and power isolators are there Job is on Croydon north Make an offer please

Hi , Looking for a licensed electrician to complete two tasks Install two heat lamps/ exhaust fan combos in my bathrooms And Change a light fitting in the kitchen

Need electrical work done for renowation of 2 bathrooms. New lights and exhaust fan will be provided. Only quote for labour and material cost for switches and switch box. Bathroom-1 Task 1 - Temporary disconnection of existing switches & lights (So that all plaster boards can be replaced for bathroom renovation) Task 2 - Install the switches and lights after renowation Bathroom - 2 Install of lights and exhaust fan for new bathroom

I need an electrician to flip over a ct clamp. Takes less tac a minute

I need an electrician to fix some led strips in a kiosk inside a shopping centre I have bought new led strips already, need someone to who can install them.

Finish off installing 1 down light and check wiring of 2 gang to 3 gang switch and connection to downlight. switch, cable, downlight and cable in place.

I have a down light that keeps flickering after the LED bulb has been changed. It’s likely the transformer that needs replacing. The roof cavity doesn’t need to be entered as the transformer can be extracted via the light bulb outlet

The property has an NBN (FTTC) connection but the point is the old style phone jack (cream coloured plug - photo attached), that requires an adapter for use. Ideally we would like to replace the adaptor to a newer style point. At the same time if it could be relocated in the lounge as it's currently in a bedroom which is inefficient.

I need (1) smoke alarm check and compliance certificate issued as per VIC govt legislation for annual smoke alarm rental property check and (2) replace 2 x damaged powerpoints at the same property (see photos of the 2 damaged powerpoints) Please make your offer inclusive of all materials, labour, compliance certificate and airtasker fees

Install 3 down lights add 2 power points remove fluorescent light

Electrician to install 3 new downlight.

Need the following 1. fit a light fixture in one room. 2. fix/refit 2 motion detector lights in the driveway. 3. Change the bulb of 2 light fixtures.

Looking to have licensed electrician to fit off 5 power points and install 2 power points in bathroom for led mirrors, more work to be considered afterwards

Looking for a licensed electrician to; - Disconnect and remove 6 batten lights - Rewire remaining 6 batten lines to one switch (currently all on separate switches) - Ensure all electrical in garage is to code Needs to be complete by 18 August.

One of my front lights It will trip and The lights on this line are all off. when I press this switch, (sometime) There is also the smoke alarm.need change battery.

I need an electrician to do the following works in my garage: 1- replace the old florescent lamp with two 40W LED batten light. I will pay $150 separately for the lamps. 2- Add a new power point in the other side of the garage. All the wiring are surface conduit wiring. In addition, there is electricity wiring around 1 meter away from the required place. 3- Check the earth connection of the existing power point as my charger gives earth error. I believe it is problem in the power point but if finding the problem and solving it took more than one and half hour. I will pay $100 for any extra hour.

Install a 5-pin socket, wiring to electrical box and upgrade RCD to support an electric vehicle charger on a dedicated 40A circuit breaker. Install 8x 90mm LED downlights and wiring in the ceiling of a single story home in the dining room area.