Find experienced local carpenters in Queens Park

Hi.. I need the big wood frame for making a rug with tufting gun, basically is just a wood frame for hanging the fabric. Please check the picture. I'm still thinking for the size. The size going to be lil bit smaller than this. I also don't know for the budget to make this.

Hi I need to replace my laminated kitchen benchtop with sink cutting. Please quote

Help Install 11m2 Decking No digging required, install on top of pavers

To make storage covered shelf in garage

i am looking to cover my alfresco area of approx. 6sq.m to avoid rain and heat. If anyone has knowledge and idea and time to build this

New 1.5mtr garden shed installation

Breaking of the side wall to make a continuation of the L bench top. install a microwave and oven cabinet . change all cabinet doors with new laminate and add more cabinets .

Minor repairs to 3 Ikea “Bonde” storage cabinets: Need to add new backing sheet to 1 of 3 Ikea wall cabinets. Some of the shelves inner supports need regluing or replacing to strengthen the cabinets. Minor repainting may be required. Will need to assist to help move the cabinets inside once work is completed. Cabinets will need to be secured to wall. I can source the backing material from our local Bunnings if needed. Measurements for each cabinet (approx): 220cm H 74cm W 40cm D Must be experienced, have qualifications

Need to raise shed roof and cover sides with colourbond and plywood with ceiling and new door. Also need a car port. Need a creative handyman who has similar experience . The job is asap and in queens park (wa) 6107. Need quote first. Happy to pay hourly rate or consider a lump sum amount for complete task Thanks for help 0425838090

Need a lean to shed at the side of the garage. Size is about 1.4m x 6m.

hi,, I have 2 x Metod ikea cabinets that I'd like mounted in my kitchen, above the splash back. They will hold some weight in them. My walls are thermalite so I'd like someone with experience with thermalite

Hi, Could you please give me a quote for two small cat doors to be cut into a cabinet and for a shelf to be put in horizontally dividing the two sections. It’s MDF with wood veneer.

Renovated our kitchen. Took out old island now there is a gap that’s needs filling with laminated flooring. Gap is 1.1 x 0.8

I have brought this narrow garden shed from Bunnings to be installed in a corner nuke between my house and neighbors house. It's 3m by 0.8m two door (tunnel shed). Just thought someone can assemble and install it for me with not much cost. A rivet gun and a good skrewdriver (drill) soft hammer are needed. Haven't done this before so don't know how long it takes, might take 4/5 hours. Some time this week would be good.