Find experienced local carpenters in Berwick

front door stain side concrete painting garage concrete painting driveway seal front retaining wall staining

I need an experienced Carpenter or Builder to help me renovate my Pergola roof withe me. I will supply all the materials and also help build this (I am very handy myself). I have another young tradie helping out as well, so looking to get this done by paying a daily rate for guidance (for context, I have build a fence in the past in similar manner and I am quite handy myself)

Fix the 3 wall cabinet on wall it’s already assembled 3x600 cabinets

I would like a catio door and frame in my side alley to allow for easy access for humans to my backyard like or similar to the one pictured

Need quote for buff & recoat on timber floors in 3-bed house and study , Berwick. Floors in good condition with surface scratches - see photos attached. Need work completed before Dec 10. Can you inspect and provide quote?

The bottom cabinets only I have kitchen cabinets that are 20mm out and need to be straightened asap for new bench top Don’t care about damage to backing as I am renovating Open to offers Need kick boards installed

Gerni , stain and shiny finish

Need to install a timber slats room divider as shown in picture. Please quote including material cost. Walnut / Chocolate stain as shown in the picture. Fitting area approx. 2.4m H x 1m W x 0.2m D

Need a bed frame made with built in study table and storage as per attached photo.

Rain water drainage join plastic socket replacement. Plastic joint that connect gutter pipe to ground drainage pipe is broken it needs new join socket. Please see the picture.

Install cabinet for new rangehood - Old rangehood and the cabinet around it have been removed (attached picture of how it was before) - The old cabinet is still good. Can be reused with some modifications. Ok with a new one if its easier - The old doors need to be reused - New rangehood is Bosch 90cm Series 4 slideout (DFS097A51A) Dimension of the cavity - Width: 90cm - Depth: 30cm (wall to door) - Height: 72cm (bulkhead to cabinet bottom) Dimensions of the doors - Width: 45cm - Depth: 16mm - Height: 69cm

New Cabinet to be created of dimensions 500mm X 285mm to support Schweigen HN-6C Rangehood

Experience cabinet maker/carpenter required to make an install shelving solution in small walk-in pantry.

It’s the facing of kitchen cabinets covering the gap between ceiling and top of the cabinets and also need a quote for changing couple of wardrobe’s door to sliding doors and fixing few wardrobes

Doing a bathroom renno Looking to have 2 cavity sliders installed 1 dry wall to be frames to close the door way Frame a bench seat in the shower Cut the joists for a shower Some Demo work Cement sheet on 3 bathrooms including floors Replace a window Build pantry shelves Lay hybrid floor boards etc Deck restoration and new deck build Plastering Plenty of work for the right person for a long time Will do daily rate minimum 8 hrs a day. Advertised task price is for 1 hr

Looking for a skilled carpenter or handyman to repair or replace a wooden pole on a front porch. The pole runs from the porch roof to the tiled floor and may require structural reinforcement, replacement, or refinishing to match the existing design. Must have experience with porch or exterior woodwork.

Need to fix the chipping of a wooden hand rail at the bottom of stairs.

The shelves in our walk-in robe are old and beginning to crack. I'd like to have them replaced with new ones, and potentially redesign the walk-in robe by upgrading to a better shelving and storage system throughout. I am looking for someone with carpentry skills who is willing and able to think "big picture" about this walk-in robe.

Hi There, We have an intergrated fridge (built in to the Kitchen cubpoards) The handles have become WORN and we want to replace them - but replacing them means we have to take the fridge off or do something that we just can't figure out ourselves. Have you done this before? Its a strange request so likely not - but we're hoping to find a cabinet maker who can, perhaps very quickly and easily, change over the door handles for us. Pics attached. Hope its an easy job - happy to pay for the time and effort

Need a carpenter to build walls for a room. Room Size around 3m(L) x 1.8m(W) x 1.8m(H). Need someone who can build the framing and I'd like the walls to be made of 18mm MDF instead of plasterboard. Requirements: - Must have the skills and tools to cut the MDF precisely to size as Im looking for perfect fitting. -Has a van or ute to bring the materials from Bunnings (MDF comes in 2.4m x 1.2m boards) Can start soon.