Find experienced local roofers in ACT

I need a handyman to access my fan-coil unit which i believe is in the roof and install a faikin unit into the Daikin AC. https://www.faikin.au/pages/faikin-origins I have contacted the faikin creator to confirm it is compatible with my AC Unit. I need help with installing the unit and then I will confirm connectivity. Instructions from Faikin to me below: FDYA160AV1 is a ducted “indoor unit”. That means the air you feel at the vents is coming from ducts connected to a separate fan-coil unit that’s usually in the ceiling space (roof) or under the house, not a wall-mounted head in the room. So yes, installation is done at the indoor unit itself, which typically means getting access in the roof/underfloor. Have attached some pictures for guidance. You'll need a Faikin and Type C cable combo for your unit. The FDYA series are common here in Oz, and I've send dozens of unit out without issue. Where you’ll be installing it (ducted setup) You’re looking for a big metal box roughly the size of a large suitcase, with ductwork coming off it. Commonly you’ll see: the indoor unit (FDYA160AV1) in roof space/underfloor a zone controller somewhere accessible (often near the return air grille, in a cupboard, or mounted near the unit) multiple ducts feeding different rooms Faikin connects to the indoor unit control circuit board, not the wall controller or the vents. Basic install Isolate power to the system at the breaker (important). Access the indoor unit in the roof/underfloor. Open the electrical/control cover. Plug Faikin into the correct connector on the control board. The Type C cable has three ends, one goes to the Faikin, and two to the A/C circuit board (sockets are labelled X35A and X50A). Mount the module so the antenna isn’t pressed against metal. Restore power, join it to Wi-Fi, then integrate with Home Assistant (MQTT or the standard Daikin integration).

Looking for an experienced worker to install underfloor insulation beneath a 1970s red brick duplex in Hughes, ACT. The job covers roughly 40 sqm, including the living area, kitchen, entry, and laundry. Key details: • Low crawl space: limited clearance under the house — must be comfortable working in a tight area. • Materials supplied by me (see below). • Tools and fastening equipment supplied by you. • Seeking someone experienced with underfloor installation or confined-space work. Materials I’ll supply: • Polyester or foil-backed underfloor insulation batts/rolls (pre-cut to joist width). • Fixing straps or insulation strapping tape (depending on material type). • Protective face mask and coveralls (optional, if you prefer your own gear, that’s fine). You’ll need to bring: Staples and fasteners (if required for your preferred installation method). Staple gun, cordless drill, or fastening tools suited for subfloor work. • Torch or lighting for underfloor space. • Drop sheet or kneeling pad (optional, depending on comfort).

Gutter is blocked . You

Need a : roof tiler/repair to replace 6 tiles. Plasterer to fix internal water damage. Painter to pint over plaster after dried.

Require a roofer to do a maintenance check of tiles and replace any that are broken for a small 2 bedroom town house. These were done about 2 years ago. A clearing of the gutters and leaves would also be ideal (these were done 6 months ago). I will also require work to the small front pergola with possible flashing, and a quote to fix the fall/piping from the carport roof. Have used $100, but happy for you to let me know a rough quote for the tiles and gutter clean.

Add new panels to an existing solar system.

Assembly of EasyShed Tall Gable Roof (model ETG-D3015) garden shed with supplied concrete fixings 8pk. Shed size 3m x 1.51m x 2.27m. See attached photo. The concrete slab is already constructed. See attached photo.

Clean and remove all debris from gutters.

Clean gutters on single level brick house

Need a tv input in a room which means cables need to be run in roof

Hi, I want to replace my current cloth pergola roof ideally with a polycarbonate or similar structure (not cloth). I need advice on what roof to buy (reasonable options) that will go on the existing metal structure. I will then buy the roof and will require assistance in installing it (after removing the current roof). Please provide a quote for this end to end process (I have just put a random "budget" for the purpose of the task). Thank you

Gutter cleaning service for single storey house with gutter guards

Tiling and waterproofing Shower base and walls 900 x 900

I need someone to instal a small hook in my veranda ceiling and help me string some fairy lights up. The ceiling of the veranda is about 3 metres high. I have a small step ladder but you may prefer to bring your own. The ceiling has 3 hooks already, it's only the 4th that needs installing.

Small house one level- clean gutters before sale.

2 storey town house but only half the gutters are mine

I am looking for someone professional and experienced to help with cleaning the gutters and downpipes at my two-storey townhouse. I have gutter guards installed, so hopefully the gutter cleaning part would be fairly straightforward.

I need insulation installed under the house floor. The house is raised, there is a door that you can enter from, there light that comes through some vents under the house. Refer to photos. Person can crouch in certain areas and crawl in others. I’ve installed about 25 matts already but I’m inexperienced and therefore its time consuming for me, I also work full time during weekdays and my weekends are quite full.

Roof ridge capping repair (10cm piece)and reseal exhaust fan outlet

Two plastic panels on shed roof have disintegrated over time and left holes in roof. I am not sure how much this usually costs so am open to offers