Find gutter repair professionals in ACT

Supply and install of approx 35 linear meters of new colorbond guttering, and fascia cover including 5 downpipes and its accessories. Rebed & repoint the ridge caps

Need someone to sand and paint the eaves, fascias, and gutters on my four bedroom single storey property. Some of the gutters are only accessible by ladder.

🏠 Gutter Replacement – Canberra Job: Replace approximately 30m of existing gutters I’m looking for an experienced gutter/roofing professional to remove and replace the existing gutters at my property in Canberra. Scope of work: * Approximately 15m of gutter at the front and 15m at the rear (30m total) * Remove and dispose of existing gutters * Supply and install new Colorbond gutters – preferably Quad profile, subject to your recommendation * Replace/upgrade gutter outlets and connections where required * Check and ensure adequate fall toward downpipes * Inspect and repair/replace any damaged sections of fascia/eaves associated with the leaking gutters * Install proper flashing under the roof tiles and into the gutter where required * Ensure all joins, corners and outlets are properly sealed * Water-test the completed installation * Please advise if you identify any underlying timber/eaves damage before carrying out additional work Important: The existing gutters have been leaking and water has been getting into the eaves. There is currently a significant amount of old sealant/bitumen around the roof-to-gutter junction, so I want the underlying issue properly rectified rather than simply resealed. 📸 Photos attached showing the existing gutter and affected eaves. Please quote for: 1. Labour 2. Supply of all guttering and materials 3. Flashing 4. Downpipe/outlet work 5. Removal and disposal of old gutters 6. Any eaves/fascia repairs, quoted separately if required. Please only apply if you have experience with roof gutter replacement and tiled roof flashing. Thanks!

Looking for someone to cut back several small multi-stemmed trees growing beside our house. Some branches and stems are overhanging the tiled roof and gutters. The job is to: Cut back the branches/stems sufficiently to leave a reasonable clearance from the roof and gutters Clean the gutters and remove leaves/debris. Remove and dispose of all cut branches and gutter debris. The house is built on a slope. The end where the trees are closest to the roof, is single-storey and easily accessible per the photo. The other end of the house is two-storey.

Gutter replacement and color bond fencing

Looking for a roof plumber or handy person to replace a short 1.5-metre (approximately) section of gutter and upgrade the downpipe to fix an overflow issue. Scope of work: Remove and dispose of the existing 1.5m gutter and downpipe. Supply and install a new, larger capacity gutter profile (e.g., Hi-Front Quad) along the 1.5m run. Supply and install a new 100mm round downpipe. Colour match: Both elements must be in Woodland Grey. Sealing & Fall: Ensure correct fall toward the downpipe. All joins and end caps must be riveted and sealed to be 100% watertight. Requirements: Please bring your own ladder and tools.

Have existing pergola, guttering never installed, need gutter in place ready to run Downpipe into rainwater Tank. If possible side flushing as well.

We need ~3-4m of gutter replaced on our garden shed/garrage. We can purchase the new gutter (and required parts) but will need help transporting it.

Panel beating, welding body work to both rear top quarters. Some rust around window which needs addressing also. I can move the vehicle to you as required. Do not require finished paint just metal work repair.

HI Team, I am looking for my gutter repaired and apply water proofing. Thanks.

Sagging gutter and down pipe installation

Hi there Need assistance of someone to help install and supply 18 linear metres of nuline gutters and 2 downpipes for my single story garage . Can you help quote price including removal of old gutters thank you in advance

The roof gutter either had to be fixed or fully replaced.

Shed roof/gutter is leaking

The stormwater drain keeps blocking because the metal at the joint (as identified by the red arrow) was not cut correctly.
 The stormwater-piping needs to be pulled apart at the joint by removing the pop-rivets. 
 Then the metal at the joint needs to trimmed back using an angle-grinder. 
 Then the joint needs to be reattached by inserting new pop-rivets. 

I believe it is an easy job for someone with the right equipment eg would take less than 10mins.

Hi. We've had a bird infestation on our double-storey rooftop for a couple of years, and patchwork solutions (gutter cleaning and bird spikes), hasn't fixed this issue permanently. I'm looking to permanently remove these bird nests from our roof asap, and apply roof netting to prevent future bird infestations as well. Two requirements: 1. Remove Bird nests 2. Apply bird prevention such as gutter netting in gutters and around solar panels (purchase netting). I'm open to fair and reasonable quotes. The contractor must be able to use a ladder to the top of our double-storey rooftop. As we're heading back interstate next week, we're also looking for someone who can come in and inspect the premises themselves in the coming days, and ideally create the fix sometime this weekend if possible (happy to pay extra). Thanks for your help! Cheers Sas.

Guttering repair as brackets have come away from timber

I want to install gutters and downpipes in my enclosed pergola with a color bond roof

On a short length guitar there is an obvious leak at one end. Water has leaked out and has pushed off some render in the underlying rendered wall. Needs to be cleaned, and repaired.

Repairs to guttering in 2 places: - 1 x corner (where walls meet) has broken on house - 1 x gutter pulling away from wall on the garage