Find an experienced letterbox replacement expert in QLD

Sandstone letterbox has fallen. Needs to be stood back up so it’s level. Very heavy, so requires a winch or other equipment to move.

Install freestanding parcel letterbox - needs concrete slab approx 54cm x 78cm, small retaining wall around rear due to slope

Install new letterbox from Bunnings. Person will need to bring their own tools to do so . We will supply new letterbox and post, the rest supplied by the installer

Remove old letterbox and replace new one on timberlog

Quote to put in a letterbox . Already have the metal letterbox and round tube for paper to go in

Damaged concrete mailbox need repair

Hi You need to remove the broken letter box and install a new one! I have already purchased a letterbox, so you just need to do the installation! Many thanks

Hello, I am needing someone to fix a crack in a letterbox and a piece of door frame that is on a back patio.

Install new metal parcel letterbox

letterbox is broken off its hinge and will not open or close without it entirely breaking. It’s hard to get the key and unlock as well.

Sending pic of instructions

Broken letter box, need fixing

We need a new post mounted letterbox to be installed (digging the hole, concreting, ..., no old letterbox to be removed). Post and letterbox are made of metal.

I need a hand to bolt down a parcel letterbox - concrete screws provided. See pic

Needing someone to install an in fence parcel lettebox like shown in pic.

I need some help with installing the letterbox temporarily into the ground. I already have the letterbox and the wooden post it just fell down during the cyclone. You literally have to just put it in ground, rest all is done.

Remove old letterbox, cutting off wooden posts (and removing concrete if possible), and concreting new letterbox into same position. Concrete not supplied.

I would like some help putting up this letter box. Looks simple enough, but needs screws need to be a drilled into my fence front which is Blue Board - not concrete but still a hard material. See photos.

Broken letter box need fixed

We have a new letterbox that we want installed into our timber picket fence. Here are the instruction suggestions from the manufacturer website - the main thing to consider is to not use screws on the face and the fence and crossrail are sloping on a hill: 1. Neatly cut a suitable sized hole to accept the mailbox body size. 2. If possible, use a suitable construction adhesive (Sikaflex 252) behind the overhanging face and wall/fence. In some cases, this represents adequate installation, if not move to next step. 3. Using offcut pieces from your fence palings which have been cut to a suitable size (or alternatively use angle brackets, available from hardware store), use these to “sandwich” the fence between the face plate and these sections, fixing them to the side of the box using suitable screws. Please do not detract from the finish of the faceplate by drilling holes through it and using screws to install your mailbox.