Hire a trusted gas stove repair and installation service in VIC

I need a licensed gas fitter or plumber to remove an old gas stove and turn off the gas supply today. Please ensure everything is safely capped and disconnected Gas coming from Floor, stumped house . I will discuss the quote once we connect. Please confirm availability today. Thank you!

Installation of New 60cm gas stove to replace existing

There are two pipes running in parallel from the meter to the house, see the attached photos 1. cooktop and heater 2. hot water unit. What needs to be done: 1. Cap off a pipe At the copper T junction at the gas meter, cap off the one to the cooktop and heater. (1'' copper tube) 2. Reconnect cooktop and heater to another pipe At the hot water unit(3/4'' copper), add a T junction, and connect cooktop and heater(1/2'') to it. current joints are under the house, need about 2.5m and 5m 1/2'' pipe to connect them.

Need to fit new 90 Cm gas cooktop in place of my existing one but the cut out width is different so need to cut the stone or the wood under . The images from the bottom are attached here with . The existing is 733mm and the new width is 860

The old cooktop needs to be taken out with cut out 830 by 470mm and the new cooktop needs to be fit in with cut out 830 by 490. That means we need to cut the stone benchtop by 20mm.

gas stove ignition not working but I can still use the stove with manual lighter. Need repair.

I have replaced benchtop and needs installation of new cooktop, old one was already removed

Remove old gas cooktop and install new one (cooktops are the same size). Potentially install rangehood also.

Fix 2 of 4 gas burners which have flames that are overflowing

Need to remove gas cooktop, seal the gas pipeline and install electric cooktop if require installing new socket

We are having two issues with our Westinghouse oven - The spark on the gas hot plates are not working on any of the jobs - The power is tripping when the oven warms up above 220 degrees

Need a certified gas fitter to switch over a gas cooktop. Must have the necessary licenses to do it. Ideally, it needs to be done before Thursday, 19th. Switching from an old gas cooktop to Fisher and Paykel cooktop. Regulator and isolation valve easily accessible in cupboard next to.

One of the burners on my gas stove is not working with the ignition button - the built-in igniter doesn't ignite correctly and keeps sparking non-stop when I turn the switch on. The brand of the stove top is Bosch. Located in Springvale

Licensed plumber required to: * Disconnect and remove existing gas cooktop * Cap and seal the gas line to Australian standards * Provide compliance certificate Additionally, plumber to repair a small water pipe leak under the house: * Leak is a pinhole in the cold water pressure pipe feeding from the meter * Access is under the house * Temporary repair has been done using plumbing tape; permanent repair required Please quote including all labour, materials, and compliance documentation where required. Must be fully licensed and insured.

Replace gas cooktop with a new one

Install new gas stove from Kogan and remove old one

Licensed plumber required for the installation of new gas cooktop. 600mm 4 burner. Gas to unit is off, existing lines as pictured. New unit product code- the hood guys: GGSCG6004. Compliance certificate required upon completion.

I need an old gas stove decommissioned as we're switching to induction and electric oven.

Hi, I need a technician to install a new Westinghouse 60cm 4-Burner Gas Cooktop – in my apartment located in Melbourne CBD. • New cooktop is already onsite and already fitted in.

Need a plumber to connect a new gas cooktop which needs to be safely connected to the gas port. I can provide the cooktop but need the plumber to provide the regulator and connect to the port. Need done before 10am Friday, either later this afternoon or tomorrow morning.