Find flat roofing professionals near you

Looking for experienced roofer or builder to inspect a leaking flat roof at my investment property. The budget is indicative please make your offer. The issue is over two small rear rumpus rooms (20square meter). The roof has very little fall, resulting in water pooling and leaks during heavy rains. There is internal ceiling damage, some temporary make-safe works have been completed. I am looking for someone to: Inspect roof Consider it’s underpitched and advise on solution Advise if replacement is required and provide quote Previous roof replacement quotes have been around $13000 and I am seeking another opinion and competitive pricing. Property is tenanted so inspection will be arranged with the tenant. Please indicate your experience, whether you are licensed and insured and your availability to commence work.

The slab has been poured and we just need the shed assembled

Skillion verandah. Plans available. Building permit approved. Post holes already dug & inspected. Materials supplied. Posts into mass concrete footings. BYO tools & fixings.

Looking for an experienced wood heater installer to install a new Scandia Supremacy 300 indoor wood heater at my home. Installation required this Tuesday. I will supply all components, including: * Scandia Supremacy 300 Indoor Wood Heater * Scandia 4m Black Sleek Flue Kit * Scandia 250–380mm Tin Roof Flashing The heater location has already been selected. Ceiling height is approximately 2.15m. Scope of work: 1. Position the wood heater in the nominated location. 2. Measure and confirm the correct flue position and required clearances. 3. Cut the required opening through the internal gyprock/plasterboard ceiling. 4. Cut the required opening through the flat metal roof. 5. Install the flue kit correctly through the ceiling and roof. 6. Install and properly seal the roof flashing to ensure the penetration is fully watertight. 7. Complete the wood heater/flue installation and make sure everything is secure and correctly installed. 8. Leave the work area clean and tidy. All components will be onsite and ready. I expect the work to be relatively straightforward and approximately 2–3 hours for someone experienced with this type of installation. Please only make an offer if you have previous experience installing wood heaters and flue systems through metal roofs. When making an offer, please briefly confirm your experience with wood heater installations and whether you can attend on Tuesday.

Looking for a qualified carpenter/builder to supply and install a brand-new ground-level deck and a flat-roof pergola at our property. The site has an existing concrete slab and a brick Alfresco structure, as seen in the attached photos. Decking (49.3 m² total footprint): The entire 49.3 m² area needs to be decked over the existing concrete slab and surrounding ground level. We are tossing up between Merbau or Composite decking. Please provide separate pricing/options for both materials in your quote. Pergola / Verandah (25.55 m² total roof area): broken down as 3.5m × 5m plus an additional 2.3m × 3.5m section. Roofing Specifications: The roof must be a flat design, using mostly white Colorbond roofing. We want a portion of the roof to feature clear or dark-tinted polycarbonate/Colorbond to allow natural sunlight to filter through. Please provide a cost breakdown for two options: Standard single-skin flat roof vs. Insulated flat roof panels so we can compare the pricing difference.

Build/assemble 2.25m x 0.78m Flat Roof Shed (2.21m high) Easy Shed we have a plastic base and ply for it to sit on

“My flat roof is ageing, with several sheets leaking. Part of the roof also needs altering so I can remove the internal gutter, as that is also leaking.”

We need someone to assemble a shed for us. The brand is easy ahed and it is a flat roof, dimensions 2m x 3 m.

I have a flat roof cart which I want to remove to access driveway.

Colorbond pergola flat roof. Give quote.

We have a leak in our Colorbond steel flat roof. Water is getting through into the Gyprock ceiling in an upstairs room. We need someone experienced with metal roofing to come out, inspect the roof, locate where the water is getting in, and patch or seal it so it stops. What we need: Inspect the flat Colorbond steel roof and find the source of the leak. Check the usual suspects (flashings, screws and seals, joins, penetrations, and any rust or lifted sheeting). Carry out a patch repair on the day if possible. Let us know what was found and whether any larger follow up work is needed. We had it repaired a few years ago, now a new spot is leaking

Need EasyShed expert to build/install new 2.25m x 0.78m x 2.12m tall, Flat Roof Shed, model ETF-S2308-MM. Has just been delivered. Carton not yet opened. Shed to be installed on narrow side of the house. Hinged door needs to hinged on right-hand jamb (when looking from outside) with pad bolt on left-hand side. Shed to be located on a flat area partly concrete and partly plastic floor system tiles (already laid) - see photo. Not requiring any anchoring (unless deemed essential). Person must be EasyShed certified and bring all tools and any benches required to complete the job. Happy to assist you with any basic tasks but will rely on you to do the main job. Date to be done: 1 day within the following: Tue 2 June or between Mon 8 until Thurs 11 June.

I’m looking for someone experienced with Starlink installations to install a Starlink dish on a one-storey flat roof in Ararat. The job includes: * Mounting and securing the Starlink dish properly * Positioning it for the best signal * Neat and safe cable routing into the building * Ensuring installation is weatherproof and secure Please bring any required tools/equipment or let me know beforehand if anything additional is needed. Experience with Starlink installations preferred. Location: Ararat, VIC

Assemble an easyshed: 2.25m x 0.78m Flat Roof Garden Shed

Flat roof pergola 6x4 metres

Need help fitting a steel flat roof rack platform to a Prado 120. I’ve already installed the rails onto the car

Assembly of Easy Shed 3m x 0.78m Flat Roof Shed

Reseal roof area approx 5 m x 6 m with 3 sky lights

Flat pack assembly and installation of easy shed with 2.25m x 0.78m Flat Roof Shed. To be installed on to concrete slab

Task: Assemble and install an EasyShed 3.75m x 1.5m Flat Roof Shed onto an existing concrete slab at my home in Brisbane. Details: Concrete slab already in place Shed kit supplied on site (boxed) EasyShed concrete dynabolt anchor kit supplied Location: side of house with clear access Fixing shed securely to slab required Prefer someone experienced with EasyShed or similar metal shed installs