Find experienced local fencing contractors in Sandringham VIC

I need a 3.9M wide double swing gate installed (similar to the picture). Onto brick posts. Needs to be around 1.9m tall in middle section.

As you can see by the photo the gate is in disrepair and either needs re-welding with sections replaced or the whole gate replaced. I need someone available today to meet me on site and give me a price.

An existing balcony needs a new fence. The design and materials is up for consideration and would look for suggestions.

Looking for a side fence to be built to maximum height. Ideally you capping on top. Length is 10m x 1.8m Standard wood pailing.

3-4m of stick fence removed and replaced with a timber fence and a matching gate for the side of the house

We have a Sureguard Pingg String set up along our back fences. About 45m in total. But some of the wires and the little posts had snapped so it’s needs maintenance. Looking for someone to get back going again.

Looking for someone to build a fence and gate on the side of our house. We already have a fence & gate on one side, (see picture), we want the other side to look the same. There is currently a large hedge there which I will remove prior to fence being built, the gap is roughly 280cm. We will do the painting so just need fence installing.

We have a glass pool fence and gate. The gate has dropped and it’s very difficult to close. See photos for more detail. Pics of hinges included too. Screws to hinges have rusted so could these be replaced too please. Only 2 hinges on gate.

Install a letterbox in a picket fence.

The wooden panels in photos (it is an inner or secondary boundary fence) require a scraping firstly & then a light sand. A primer has been applied to the slats already to loosen the product. Fence dimensions approx 2.5m x 12m + an additional 8 panel length in last photo which is approx 5m long. The additional 8 panel length has already been scraped - only needs a sand. Any day from tomorrow

To accommodate a delivery, we need to temporarily remove a single only one) glass pool fence panel, and then reinstall it back into place after the delivery is complete. Removal needs to be on Tues 15/8 or Wed 16/8 before 9:30am, and reinstall needs to be Wed 16/8 after 12:00pm. Should be a very simple job for someone who knows there way around pool fences (we don't).

Needing replacement of old wood paling fence. Roughly 18.5m length shared with 2 neighbours. Palings are 1800mm height. Posts need to be redone.

Install new wooden fence between driveway and neighbours driveway. Renovate wooden gate. Renovate wooden fence

11.5m long 1.8m treated pine paling fence. Required materials: - 125x75mm white cypress/ hardwood post. - Posts with concrete footings at a minimum 900mm depth due to sandy soil in the area. - 75x50mm treated pine rails. - 1.8m 150x12mm and 100x12mm treated pine palings. - 150x25mm treated pine plinth board. -All galvanised nails. The old fence is full removed. The site is completely cleared and clean. The soil is all sand so easy digging.

Build side fence with gate. 2300 wide fence, and will need a gate in the middle. Have already got pickets on site, would just need 2 posts for gate, concrete and 2 posts either side which can go into brick. Will also need gate frame.

Need to build a 3.3w and 2m height masonry fence and match the other fence.

Demolish and remove 3 m wide limestone fence and install wooden fence of 1,5 meter. While demolishing the fence border it with a protecting mesh

Install a 100 x 100 dressed cypress posts onto post support bracket. Install treated pine plinths, rails and pickets.

We currently have a balustrade fence that is rotting. This fence goes along the pathway to our house. There is some stairs. We need this balustrade replaced and then we want it to be extended by about 3 metres

Require some adjustments to swimming pool gate latches (glass panels) to meet the VIC Compliance Certificate. Gates are not closing/returning to the closed position from a stationary position.