Find trusted local electricians in Reservoir VIC

We want the tv and power sockets to be installed on the opposite wall underneath the split system. We’ll need to check if it can be centred first.

On/off switches for two power switches are loose (don't flick on and off cleanly).

Need routine cleaning service for my aircon

Remove existing wall mounted split system and condenser and dispose off. Install new wall mounted unit and condenser. Wall mounted unit to be located in living space and condenser on roof above. Modernist unit with flat roof, easily accessible with ladder. Driveway access.

We have 2 retro heaters attached to the wall that we would like removed/ decommissioned. There is also a conduit running from the GPO to the heater that we would like removed

LG inverter airconditioning unit needs servicing and Dip catchment pump clean out

Need help of an electrician for disconnecting the smoke alarm and reconnecting it after 2 hours. This is for a pest control

I have an older Breezair roof-mounted evaporative cooling unit that will not start. Symptoms: Wall controller powers on and responds normally When COOL is pressed, controller sends command (faint electrical hum audible at controller) Unit does not start: no fan, no water sound, no air through vents Previously showed “Preparing to start”; controller logic now reset but roof unit still unresponsive Checks already completed (by homeowner): Water supply confirmed (hose disconnected at roof – strong flow) Solenoid physically located on roof (no activation / no click) Breakers checked and reset (main board + garage sub-board) No wall isolation switch (older install) Windows open during testing Controller confirmed operational (timer reset, responds correctly) Likely fault: Failed solenoid coil Or failed control relay / output on roof PCB Possibly solenoid wiring What I’m looking for: Licensed electrician or evaporative cooling technician Experience with Breezair / older evaporative systems Diagnosis and repair only (not interested in replacement sales) Location: Reservoir, VIC Roof access: Yes Parking: Available Please comment with: Your experience with evaporative coolers / Breezair Call-out + hourly rate Whether you carry solenoid / common Breezair parts Photos available if required.

Downlight not working, new globe

Split system is blowing hot air - an error code popped up a few weeks ago which said there was a leak

I need a licensed electrician to install 1 or 2 Power points outside that are compliant .

I work for an organisation and will be funding my clients air con installation. The aircon unit is a Kogan SmarterHome 3.5kW Inverter Split system Air Conditioner (Reverse Cycle). It will need to be installed in the lounge room which has an external wall.

Install 3 smoke alarms in my house

I need 3 smoke alarms installed

Install Revel Sauna heater and light and wireless controls for sauna

Looking for a licensed electrician to remove an existing surface-mounted LED panel in a bathroom and install new recessed LED downlights. Scope of work: • Disconnect and remove existing light fixture • Supply and install 2–3 IP-rated LED downlights (bathroom safe, tri-colour preferred) • Run wiring from existing light point to each downlight location • Install plug bases or drivers as required • Test and certify to Australian standards Ceiling condition: • Old light will leave a hole/mark on ceiling • Please include basic patch and paint to blend the area, OR recommend a neat cover plate solution • Ceiling is standard plasterboard Room details: • Bathroom, approx. 2.5m x 2.5m (small space) • Standard ceiling height Requirements: • Must be a licensed electrician • Must provide Certificate of Electrical Safety • Must supply compliant, good-quality downlights • Australian standards compliant products only Preferences (not mandatory): • Tri-colour selectable • Dimmable driver • Warm–neutral white output preferred Flexible on timing, preferably within 1–2 weeks. Budget: Open to quotes based on labour + materials looking for realistic pricing from a professional

Remove two existing light fittings and replace them with new fittings, which I have already. Must have licence and insurance.

removing a power point as part of some wall repairs. Could you please disconnect and remove the GPO and wiring completely so the wall can be plastered over. I need the outlet decommissioned safely and the wiring either removed back to the previous junction point or otherwise made compliant for a wall with no access plate.

Need to move the switchboard to the right where is red marked. There is plenty of room to pull on the main power. Need a licensed electrician to quote me on the job to comply with regulations, and if needed upgrade the box and those circuit breakers that need to be adjusted. Most of the circuits are recently upgraded to RCB type. Your quote needs to specify exactly what will need to change before upgrading including the switchboard and any circuit breaker Photos attached

Hi, we are looking for a qualified electrician to install a new Bathroom Heat Fan Light.