Hire a professional washing machine repair service in Reservoir VIC

Hoover washing machine showing a error 8 and not spining

Need a door seal replacement I already have the new part to put in

Replace seal on front loader washing machine and give it a service

I need someone to fix the washing machine hose leakage I think need for new hose the water hose

My washing machine (a Euromaid WM7) has a slow drip at the bottom of the plug in the image attached & would like this repaired. I've drained & cleared away any obstructions & the thread & rubber on the plug appears to be fine but it won't go past the anti-vibration locking notch.

I need my heavy clothes dryer lifted up and put on top of my washing machine to save space. I have a bad back so won’t be able to help wort the lifting.

Need to attach new washing machine to all water/pipe outlets, cold water sink has stopper screwed on too tightly. You may need to bring hydrolic spanner to undo to attach new hose pipe from the washing machine. Also help lift the dryer back on top of washing machine or maybe attach it to the wall ?

Water leak in laundry area leaking washing machine taps

Water is leaking on the floor when we do our washing

Remove a rusted/stripped screw     The screw is located on the front panel, just under/near the detergent drawer. It’s heavily rusted (likely from detergent/moisture exposure) and the head is partially stripped, so it’s not coming out with standard tools. Install a new door seal (gasket)     I already have the replacement seal and parts ready. Once the screw issue is sorted, I need the door seal properly fitted and secured. What I’ve tried so far: Applied WD-40 and let it soak Attempted removal with socket wrench (imperial sizes) The screw is still stuck and difficult to grip What I need: Safe removal of the stuck screw without damaging the panel Installation of the new door seal (correct fit and alignment) Use of appropriate tools (e.g. metric sockets, screw extractors, clamps for seal) Notes: I already have all replacement parts Prefer someone with experience in washing machine or general appliance repair Open to drilling/extraction methods if required, but would prefer minimal damage.

LG DirectDrive 7kg Washing Machine leaks - seems to be during rinse cycle. Drain hose seems to be working OK.

Need to connect my washing machine to my tap and waste water - need an L joint to connect it

LG1200D front load washing machine. Punctured drain plug. Attempted accessing from the back of the machine but unable to reach it. Need assistance removing front panel of machine to assess damage to see whether it can be patched with tape vs replacement of drain plug. Photo shows pipe that has puncture and model number of the machine.

Pick small washing machine and small frige, plus installation Pickup location: Reservoir VIC, Australia Drop-off location: Carlton VIC, Australia Removals size: Apartment Stairs: At delivery

Washing machine leaks on the floor when it’s being used. It’s not due to the hoses/drain connections being loose - I checked. It leaks from underneath. I don’t think it’s the door seal either since all the water is at the back of the machine, not the front. It’s a 2 year old Samsung washing machine. Need someone to come look and repair.

Hi, I have a Miele front loader washing machine that is not draining properly. I’ve cleaned the filter at the bottom, but after every wash a significant amount of water still comes out when I open it. Clothes are also coming out quite damp even on a 1200 spin. This suggests there may be a blockage in the pump or hose, or an issue with the drain pump. Looking for someone experienced with washing machine repairs (especially Miele or front loaders) to: Inspect and clear any blockage Check the drain pump and hoses Ensure it is draining properly again Machine is otherwise working and turns on fine. Located in Reservoir. Flexible with timing. Please only respond if you have experience repairing washing machines (not just general handyman work).

Washing machine is making a squeaking sound during the spin cycle. Please submit a quote.

The drum makes hitting sound when it spins.

Hi, I have a front-load washing machine (brand: Euromaid) and the Start/Pause button is faulty and does not press properly, so the machine will not start. The rest of the machine is working fine. I’m looking for an experienced technician to inspect and repair or replace the button as soon as possible.

Hi, I have a Hisense front load washing machine (approx. 5 years old) showing F-03 error in the last 10–13 minutes of the wash cycle. What’s happening: • Error appears during the drain/spin stage • Pump filter has been checked and cleaned • Drain pump spins with normal magnetic resistance • Internal hoses checked – no visible blockage • No sludge build-up found • Drain hose not kinked The machine still errors near the end of the cycle. What I need: • Proper diagnosis of the F-03 drain fault • Repair or replacement of faulty component (likely drain pump, pressure sensor, or related issue) Please quote including: • Call-out fee • Labour • Estimated cost if pump replacement is required