Find trusted local electricians in QLD

Initial Inspection and Fault Finding

(EPS) blackout circuit to be added to my switch box to power up the house during the storm season!

Hi, Looking for a licensed electrician for a few straightforward jobs at my place in Brisbane. Prefer fair hourly-based pricing so I can decide the scope based on cost and budget. Possible tasks (I may start with just a couple depending on the rate): • Install a wall lamp (cables, wiring and switch already in place) • Install a new powerpoint in the garage • Install another new powerpoint • Diagnose and fix an existing powerpoint that has no power • Diagnose and fix AC unit that has no power • Run three Cat 6 cables Evaluate and advise if a surge protector needed Happy for you to do a quick on-site look first so we can confirm exact scope and pricing. I’d like to get everything done eventually, but will prioritise based on hourly rate and my budget. Please reply with: • Your hourly rate (and any call-out / minimum charge) • Whether you’re happy to work hourly or prefer fixed quotes • Availability Thanks!

Solar Battery and EV car wall charger

Replace 4 plug in down lights in 4m high ceiling, needs own ladder

Disposing disconnected hot water heater system

Installation of Two External Power Points – Upstairs Balcony Require a licensed electrician to supply and install two weatherproof outdoor power points on the upstairs balcony.

1. Move power point for wall mounted tv, as pictured 2. 2x runs of cat 6 cable from 2 rooms away 3 runs speaker cable to rear speaker location

Old ceiling fan has died. I have bought a new one and need the old one replaced. It has a light and remote.

Hi, We need a licensed electrician for add power points in one room.. ​Need to expand 1 existing power point into 3 double power points. ​Ideally, I'd like them distributed across the room (e.g., one on the left wall, one on the right wall). ​Surface-mounted wiring / conduits are perfectly fine. ​​Please provide a Certificate of Testing and Compliance upon completion. ​Please supply pvc conduits for powerpoint wires and power point plates. ​Let us know your availability and quote. Thanks!

After licensed electrician for the following tasks: - 1 downlight install (downstairs bathroom - existing light replacement) - 3 electrical switch install (2 pantry and 1 fridge) - 1 electrical switch swap (downstairs backlight) - 2 light install (1200 x 400 and a 400 x 400) to existing mains and solar panel on external roof - 1 swap damaged fan over I have all the products (downlight, lights,switches and fan.

An electrician to remove the existing hanging light and replace it with a new hanging light.

3x oyster lights 2x other need to be removed. Would like supply and install cost for 5 downlights to replace them and one additional light (wire in ceiling but nothing attached) also include a cost to patch any holes in ceiling as part of the job.

I have ice machine need a new electric wire and can someone fixed the dough roller wires

Looking for a licenced electrician switch has been damaged for kitchen appliances, exposing internal wiring and components. Hoping for inclose and repair

I need a fully licensed electrician to remove one faulty outdoor sensor light and replace it with a standard bunker light fixture. The Details: • The Fixture: I already have the new bunker light on-site. You do not need to supply any materials.The Wiring: This is a straight swap-out replacing a previous light. It utilizes the existing wiring, wall mount, and switch layout. No new cabling or complex diagnostics are required.Access: Easy single-story ground access. You will just need a standard A-frame stepladder to reach it.Time: This is a very quick 15-minute job, perfect as a filler if you are working nearby or traveling home through the area.Requirements:

I need a three small electrical things done. 1. 2 lantern lights attached to the front of the garage (1 to each panel). Wiring is in place and ready to go. I have the lights. 2. PowerPoint installed for garage door. Wiring is in place and ready to go. 3. Sensor light to be installed. Wiring is in place and ready to go.

I need a licensed electrician to: Remove nine existing round ceiling light fittings and install nine supplied Lustre II LED flush-mount fittings. Remove one existing fluorescent tube-light fitting and install one supplied GE Riker 1200 mm LED batten. All replacements are at existing light points. I will supply all 10 new fittings. Photos of the existing fittings and replacements are attached. Please quote a fixed total including removal of existing fittings, mounting hardware, installation, electrical testing, call-out and GST where applicable. Please state whether disposal is included. Any additional work or charges must be approved beforehand.

Licensed Electrician – Install LED Garage Light & Replace 2 Power Points Job Description: Looking for a qualified and licensed electrician to complete a small electrical job at my home. Work required: 1. Garage LED Light Installation * Install a new 40W LED batten light, replacing an old fluorescent fitting. * Old fitting has already been removed. * Existing wiring is accessible (see photos). * New LED fitting, mounting screws and wall plugs supplied. 2. Replace 2 Existing Power Points * Replace two standard double power points with new Jackson double power points featuring USB-A and USB-C charging ports. * New power points already purchased and supplied. * Straight replacements in existing locations. Additional Information: * All new fittings and materials mentioned above are supplied. * Easy access to both locations. * Electrician to provide necessary tools, complete installation safely and test all fittings. * Must hold a current Queensland electrical contractor licence. Looking for a competitive, fixed-price quote for this straightforward job. Flexible with timing and happy to work around your availability. Photos attached.

When changing the lightbulb in my walk in robe the housing broke due to being brittle(original from house build 15 years ago. So I need someone to come do a quick job to replace the fitting please. I believe this will require an electrician. Please supply the fitting also. Would like this done ASAP please!