Find trusted local electricians in Melbourne Eastern Suburbs

My single-phase “Fused Overhead Line Connection Box” is damaged, and United Energy has issued a Defect Notice requiring replacement. This is not an emergency task. The box is located at the roof of a single story garage, easy access. Any offer should cover all supplies and labour to ensure the defect is resolved.

Install Pendant Light over Kitchen Island Please see photos There are 6 spotlights in the kitchen and a 5 gang switch. There are no direct spot lights over the kitchen island. Available most weekends or some weekday mornings next week. Cheers James

Fix the broken bulb socket

Install powerpoint on the two walls pictured.

Looking for someone experienced with smoke alarms to attend our house after 6:30 pm today or before 3:00 pm tomorrow to diagnose and fix a smoke alarm that is continuously sounding. The alarm is currently doing three rapid beeps, short pause, then three rapid beeps again continuously. There is no obvious smoke or fire present, and the alarm has continued sounding despite attempts to silence it. We are currently away from home and have a dog sitter staying at the house. She will be home from 6:30 pm today until 3:00 pm tomorrow, so attendance would need to be during that time. Task would include: • Diagnose the cause of the alarm • Reset, repair or replace the alarm if required • Check interconnected alarms if applicable • Make sure the system is functioning normally before leaving Please bring any suitable replacement smoke alarm or battery that may be required. Preference for a licensed electrician or experienced smoke alarm technician. Please let me know your availability and approximate cost. Thanks, Pete

Install a light fitting to current lught globe

We need help to 1) change two pendant light globes that are really high and 2) lower a set of pendant lights 3) hard wire Ring camera and doorbell. We are located in Surrey Hills. Please ignore budget figure of $10. I had to put a number down Licensed electricians only please

Install Downlights, couple of Ethernet ports and couple of power points

I have a powered LED bathroom mirror that hasn’t arrived yet. Rough in wiring so it can be connected to mirror.

We have a factory being re installed into a factory in box hill south. We need someone to source and install 4 batton lights like in the photos to replicate what was previously there. Would need 2 visits one to rough in the cable and next to install the lights. Have existing lights to put back in. Photos are of the original office. We have the frame back up just now.

Replace existing double power point. Both sockets have very loose plug retention. Existing wiring/location unchanged. Please supply and install a standard double GPO. Must be a licensed Victorian electrician and provide Certificate of Electrical Safety.

I’m looking for a licensed electrician to replace an existing ceiling pendant light in my apartment. I have already purchased the exact replacement pendant light, so no parts are required—just installation. The existing light has a cracked shade and the replacement is the same model, so it should be a straightforward, quick job for a qualified electrician. Requirements: * Must be a licensed electrician. * Please bring any tools required for installation. * Please provide a tax invoice on completion of the work (or within 24 hours), as this is required for my tenancy records. Please let me know your availability and your quote. Thank you.

I’m looking for a licensed electrician to inspect and repair two ceiling lights. * Light 1 (Stairwell): Located above the stairwell at approximately 5 metres high. The light flickers continuously. The bulb has already been replaced, so it may be a wiring, LED driver or fitting issue. * Light 2 (Bedroom): The ceiling light does not turn on at all. The stairwell light is approximately 5 metres high, so you’ll need a suitable extension ladder and your own tools. Please only apply if you are a licensed electrician.

I wish to add a spotlight to an existing line of 12v garden lights. And need a sensor added to my front porch. I have both the spotlight and sensor, so only requires installing and a bit of cable.

Installation of a wall light Flos Maap W1 light. Refer to info and installation details: https://professional.flos.com/en/global/stories/stories-maap/ https://flos.com/en/wo/maap/M-Maap.html?itemListName=Wall&itemListID=wall&spareparts=false

Urgent Licensed Electrician Needed Today – Disconnect Built-in Oven & Cooktop + Install Power Points I’m looking for a licensed electrician who can come ASAP (today). I am renovating my kitchen and need the following work completed: 1. Safely disconnect and isolate the power to an existing built-in electric oven/cooktop so it can be removed today. The appliance is hardwired (not plugged into a power point). 2. Install/relocate several power points for my new kitchen layout (we can discuss exact locations on site). This is the first stage of the renovation. After the plumber disconnects the gas and the old appliances are removed, I will also need a licensed electrician to return to connect the new oven and other electrical work, so there may be additional work available. Requirements * Must be a licensed electrician * Available today / ASAP * Please bring all necessary tools * Please let me know your earliest arrival time. The oven needs to be disconnected urgently because the plumber is waiting to disconnect the gas line and remove the existing appliance.

None of the lights in the house are working. The “Protected Light” breaker trips immediately when it is reset. Looking for a licensed electrician to attend, fault find, and repair the issue on the spot if possible. Please check the lighting circuit, light switches, wiring terminations, and switchboard breaker/RCBO to identify and fix the fault. It may be a faulty cable, loose termination, light switch, or breaker, but I need the exact cause diagnosed and repaired. Please only respond if you’re able to carry out the repair, not just provide a quote for a full switchboard replacement. If major work is genuinely required, please explain why before proceeding.

Electrician Required – Replace & Install Power Points & Light Switches (Single-Level Home) Scope: Looking for a licensed electrician for the following: -New double power points = 6 -Replace single power points = 4 -Replace double power points = 10 -Replace triple power point = 1 -Replace quad light switch = 1 -Single PP replaced with double PP = 1 -Replace standard single light switches = 4 -Replace single dimmer light switches = 3 -Relocate triple light switch = 1 -Relocate double power point = 1 Single-level home. Easy access with driveway parking. Power on. All work to comply with Australian Standards. Please quote your total price including labour, materials, fittings. Happy to answer any questions or provide further photos/floor plan.

Need a licensed electrician to install: 2 pendant lights (60-80 cm diameter each) 5 wall lights Replacing existing lights with no new cable run.

I have 3 bedrooms that need down lights