Find trusted local electricians in Bondi

Need a quote to replace my 5kW Mitsubishi split system air conditioner.

Change oyster lights, light switches, install led strip lighting, a new power point on the balcony and mount tv on the wall with its cord hard wired to the wall. Materials provided.

Seeking quote for installation of 3x ceiling fans in my apartment, and power point in garage. Currently have standard ceiling lights in the two bedrooms and living room which I would like to replace with ceiling fans (with lights). I am also seeking to have a power point installed in my garage. There is currently a light in there but no power point. Photos of lights and garage attached.

Need a qualified electrician to swap out some ceiling lights to pendant lights. x 5 (2 bedrooms, 2 in hallway, 1 in loungeroom) In a rental so I need to swap back lights when we move. Pics attached.

The bathroom light and fan are on the same switch. They both turn on at the same time. But the fan is on a delay so it stays on for ~10mins after the switch is off... I'd like the fan to turn off at the same time as light. Pics attached.

Hi, When I try to use my toaster all the electricity switched off. I unplugged everything from the power point and tried to put back everything on at the electric board , but the protected power doesn’t want to switch on . Is anyone can come and help me ASAP PLEASE

✔️ 5 x light switch (I need 5 x new light switches simple & white as per the photo). (I am also putting the photos of the old ones) ✔️ Fix 3 x power switches (I have the power switches) ✔️ Put the 6 new light fixing ( see photos of the new light fixing) ✔️ Change 4 light fixing (see photos of the old light fixing) Thanks

My garage has a working light, but no power point to plug in extension chords etc. I am seeking someone to install one for me.

last night the power went out and my sister was trying to reset the time on our LG aircon but I think she accidentally went into installer mode and changed some codes. There are no errors showing, but we’d like someone to check it’s all okay and also help with the filter cleaning servicing (we can’t find it inside). We’re in an apartment

Need a new smoke alarm mounted on to a wall

Dimmer light stopped working even with new bulbs, not sure why. (Electrical experience needed) Fix heater onto wall. Fix curtain rods: install extender and new curtains, fix curtain back on hooks.

Need Electrican for 3 hours for basic light fitting tasks and water heater 1. Wire and hang new hanging light 2. Fix 2 light circuits (Shelly smart device playing up possibly) 3. Move existing water heater wiring onto nearby subboard Easy access to all areas and no long distances etc

I need current fixture removed and sleeve put on. Should be quick and easy

Reconnect a wired smoke alarm

I have an old electrical switchboard that needs to be upgraded. I currently have an old federation board consisting of ceramic fuses. I require the disconnection and removal of the current board and installation of new board. I am also planning to install an AC unit and so would like to install a dedicated circuit.

Bath leaked into ceiling and lights have shorted throughout the house

Need assistance from electrician putting the HDMI into the wall and adding PowerPoints. Need to keep consoles in the cabinet and hide wires.

I require two electrical double power points installed in the rear of a bedroom cupboard. The most suitable existing PowerPoint is around 7 metres away.It is in a brick wall. You will need to run a cable from it up the wall and then along the top of the wall to the cupboard. . You will need to drill a whole through two solid brick walls of about 12 cm wide and some narrow gyprock for the cable. The cable will need to be neatly covered afterwards. The cable can be run on the outside of the walls. . It's an apartment but no neighbours impacted. Powerpoints installed in back of cupboard which is gyprock. Need a licensed electrician

Need new light fitting installed above stairs. Also need fire alarm supplied and installed

I need someone to do 3 tasks for me: 1. Replace broken light switch with a new one. The light switched has broken off the plate (refer photos) 2. Fix my Dyson vacuum to the wall. It is a brick wall and reasonably soft/sandy so bolts have pulled out in the past. Potentially better to have a wooden backing plate on the wall, and fix the Dyson vacuum to the wood? 3. Run a 10m electrical cable (which I already have) from my PowerPoint to the vacuum. You will need to use cable clips or conduits to run it around the wall and doorframe. Items needed: - new light switch - white - wall bolts for a brick wall, maybe the wooden backing plate too - cable clips or conduits (self adhesive ones are fine too)