Find local electrical rewiring electricians in QLD

Fan/light switch board was removed due to the dial was stuck and unable to turn off fan, a friend had tried to fix but was unable, i have lost power to 3 rooms, will require rewiring, new switch light already purchased

Rewire an embedded network meter (private sub-meter) to it own meter .. We are currently on an embedded network with a private sub-meter. We would like to be rewired and connected to an independent Energex-registered market meter, so that our electricity supply is billed directly by a retailer (not through the embedded network operator). The building MIRN is: 54100644824 And for your electrical meter, this also further down stream from the our meter: NMI: 31200861435

I need a 32A socket (single phase) put up in the garage, switch box is basically on the opposite side of the wall. I also need to have hot water system rewired to avoid the control load, and a timer is needed

One of my solar panel was removed by insurance company and now the whole system only works a fraction of total possible output somehow. Can someone please help me to fix this.

Sparky with license required. I need a 32A socket (single phase) put up in the garage, switch box is basically on the opposite side of the wall. I also need to have hot water system rewired to avoid the control load, and a timer is needed Some of the old ceiling fans needs to be replaced, installation only (quantity depends on the cost, up to 7) Could you pls give me a quote for the jobs above, separately

Rough in kitchen appliances and lights

Accidently ripped the wiring for the ceiling fan.just need it reattached!

Older arch lamp. 70’s style. Needs rewiring and testing

I have a vintage floor lamp that no longer turns on. Likely needs rewiring, new plug, switch or bulb holder replacement. Looking for a qualified electrician or experienced handyman to repair. Lamp is in good physical condition, just electrical fault. Located in Brisbane. Flexible timing.

My LED Christmas tree blew over in the wind, ripping the wiring from the power supply to the base of the tree out. Am hoping this can be rewired

Outdoor isolation plug needing to be rewired (is working, wires need to be reinstalled)

Need licenced electrictrician to rewire my ceiling fan so all setting work

Existing pool light has gone, the pool has been drained (slight pool of water left) need help rewiring and connecting the light so we can refill it.

I have vintage European lamp that has been flickering, so I want to take the opportunity to get it rewired with an Australian plug. I'm also wanting to lengthen the cable – it's currently 73cm long and I would like it to be about 2m. I don't have any of the supplies to do this, so I'm hoping the longer cable and Australian plug can be included in the quote! Must be a licensed electrician.

Need help with the electrical rewiring due to renovation in an apartment. Please send a quote or stop by to see the job.

We have a table lamp and a broken floor lamp that need rewiring. Table lamp needs new lamp holder and retaining ring (maybe new lamp holder). Floor lamp needs a new lamp holder and new internal cord.

I have lights that need rewiring to meet Australian Electrical standards. Some don't have earth wires etc. I am in BRISBANE.

2 wires have snapped off plug and i need them wired back into plug

Hi, I would like to request some electrical work at my property. I currently have a 10kW solar system and a 30kWh battery installed, and I’ve noticed that my electricity bill includes unnecessary amount of charges under the CL2 (Controlled Load 2) tariff. The only device connected to CL2 is my pool pump, so I would like to remove the CL2 circuit entirely. I already called to my electric provider who is Alinta energy. They will corporate once I start working with the electrician. Could you please help with the following work? Disconnect and remove the CL2 (Controlled Load 2) circuit from my switchboard. Rewire the pool pump to a standard general power/main circuit so it can run on solar and battery power.

Hi there! I’ve picked up a great old table lamp at an auction, but the plug was cut off and the cord is too short to use safely. I’d like to get it rewired and have the 60W bulb fitting checked and replaced if needed. I already have a brand-new replacement cord with an in-line switch — just need someone who knows what they’re doing to fit it properly and confirm the bulb fitting is safe/replace it if required. Happy for the work to be done at my place in Mango Hill, or I can drop the lamp to you if you’re not too far away. If you’re experienced with lamp repairs or basic electrical work, I’d love to hear from you!